Manual de instrucciones de Dakota Digital LED Tail Lights for 1973-74 Nova LAT-NR380

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
LAT-NR380
LED Tail Lights for 1973-74 Nova.

MAN# 650233

Kit Includes:

Installation:

1. Remove the tail light assembly from the vehicle by removing the original bulb sockets from the
housing. Then remove the housing hardware so it can be removed from the car. Remove the
housings from the vehicle carefully so the housing to body gaskets are not damaged.

2. Next remove the lens. The lens has tabs locking it into the plastic housing. Pry the

Resumen del contenido incluido en la página 2

5. Pass the wires through the tail light housing where the original bulb and socket were. Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the bottom of the housing. The flat side of the mounting plate should be down and the side with the slight raised center should go up into the housing. This will align the mount in the original housing. 6. Now hold the LED assembly so that it is centered over the hole where the original bulb was l

Resumen del contenido incluido en la página 3

9. Start by cutting off the existing light socket as it will not be used. Do not strip wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 10. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For