Manual de instrucciones de Dakota Digital LED Tail Lights for 1972 Impal LAT-NR181

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
LAT-NR181
LED Tail Lights for 1972 Impala 

MAN#650246

Kit Includes:

Installation:
1. Remove the tail light housing from the vehicle.
2. Remove the tail light lens.
3. Remove the light bulb.
4. Remove the original bulb connector from the back side of the housing.




5. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is
recommended.
6. Remove the nuts and back plate from the back of the new LED assembly.

Resumen del contenido incluido en la página 2

7. Insert the new LED assembly into the hole where the original bulb and connector were located. Use caution when feeding the wires through the socket opening to avoid damaging the wire insulation. 8. Feed the wires through the large hole in the back plate. Guide the back plate onto the back side of the housing. The flat side of the mounting disk should be toward the outside and the side with the slight raised center should go in towards the housing. This will align the mount in

Resumen del contenido incluido en la página 3

11. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 12. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the b