Resumen del contenido incluido en la página 1
I:>E:LPHI
Delphi Audio System
Installation
~
~ SATELLiTE
~ RADiO
.........,
~
Resumen del contenido incluido en la página 2
This symbol is intended to alert This is the safety alert symbol. A the user to the presence of It is used to alert you to potential uninsulated "dangerous voltage" personal injury hazards. Obey all CAUTION: TO REDUCE THE RISI Of ELECTRIC SHOCI. within the product's enclosure that safety messages that follow this DO NOT REMOVE REAR COVER NO USER SERVICEABLE may be of sufficient magnitude to symbol to avoid possible injury PARTS INSIDE. REFER SERVICING TO constitute a risk of electric shock or de
Resumen del contenido incluido en la página 3
What's in the Box - 4 Setting up the Delphi Audio System 4 Using SKYFilSKYFi2 with the Delphi Audio System 5 Using roadyXT with the Delphi Audio System 5 Using the Delphi Audio System with Batteries 6 Setting up the Antenna 6 Positioning the XM Antenna 6 Optimizing Antenna Position/Signal 6 Installing the XM Antenna on the Rear of the Delphi Audio System ? Indoor Installation on a Flat Surface ? Outdoor Installation or Indoor Wall Mounting ? Using the Delphi Audio System 8 Volume 8 Bass & Treble
Resumen del contenido incluido en la página 4
What's in the Box Your Delphi Audio System Kit contains the following components: 12V DC adaptor XM Antenna Battery compartment and 12V DC jack antenna cable storage Set up your Delphi Audio System by following these steps: 1. Connect the supplied 12V DC power adaptor to the jack on the rear of the Delphi Audio System, and the other end to a wall outlet. 2. Connect the XM Antenna to the antenna jack located inside the bat- tery compartment and antenna cable storage located on the bottom of the D
Resumen del contenido incluido en la página 5
Using SK'Y'FilSK¥Fi2 wittl ttle Delptli Audio S~stem~ - ... " .,-~; 1. Insert the SKYFi/SKYFi2 Receiver (sold separately) into the cradle by first pressing in on the back of the black inset cradle in the Delphi Audio System. Then letting the cradle tilt forward, carefully slide the SKYFi/SKYFi2 Receiver down into the tray so that the alignment tabs on the sides of the tray line up with the slots on SKYFi/SKYFi2 and the connector is com pletely seated. Push on the top center above the display of
Resumen del contenido incluido en la página 6
Using the Delphi Audio System with Batteries The Delphi Audio System can be used with batteries (not supplied) to allow you to listen to XM outdoors or in other locations without access to an AC power source. Alkaline or rechargeable NiCD batteries are recommended. Battery life will vary depending on how the system is operated and the type of batteries being used. It is recommended that the AC adaptor be the primary power source for the Delphi Audio System in order to preserve battery life. 1. D
Resumen del contenido incluido en la página 7
Installing the XM Antenna on the Rear of the Delphi Audio System When outdoors with a view of the southern sky, or in an area of repeater coverage, or when receiving a strong signal indoors, you can conveniently mount the antenna directly on the back of the Delphi Audio System. 1. Remove the battery compartment and antenna cable storage cover as described in "Setting up the Delphi Audio System," wind the antenna around the two cable hooks, leaving several inches of cable free, and replace the co
Resumen del contenido incluido en la página 8
2. Attach four screws to the wall using the screw-locator pattern shown here. Photocopy the pattern to use as a template. Use screws with head sizes small enough to fit in the center of each of the four holes but large enough not to pop out of the elongated sections. Leave 1/8" of the screw shanks behind the heads sticking out of the wall. T1.6in(40mm)~ E I---..-------E--,--------------------I -----y--C-~--L------------------l---.L---L~ .= N ~ ~ I ~ Photocopy this diagram ofthe screw-locator pat
Resumen del contenido incluido en la página 9
Note that the "Line Out Level" cannot be reset while the receiver is in the Delphi Audio System since the volume control should be used to control the audio output instead. If the line out setting is adjusted while in a car cradle or home stand and the receiver is later reconnected to the Delphi Audio System, it will automatically return to the prior setting the next time it is used in a vehicle adaptor or home adaptor. Bass 8c Treble Bass and treble can be adjusted by pressing the "Menu" button
Resumen del contenido incluido en la página 10
2. On placement: • Do not place the Delphi Audio System on an inclined or unstable surface. • Do not place anything within 1/2" of the side of the cabinet. The audio/ventilation ports must be unobstructed for the Delphi Audio System to operate properly and prolong the life of its components. • Since a strong magnet is used for the speakers, keep personal credit cards using magnetic coding or spring-wound watches away from the unit to prevent possible damage from the magnetic fields. 3. Do not im
Resumen del contenido incluido en la página 11
Specifications ITEM SPECIFICATION REMARK UNIT NOMINAL LIMITED Rated output (10%) at 1 KHz 1 Continuous average W >4 >3.5 power output 2 Total harmonic % >0.6 >1.0 Output: 0.5 W Frequency: 70 Hz - distortion 20 KHz Line input Frequency: 70 Hz - 180 140-235 3 Sensitivity mV 20 KHz 65-22K 70-20K -3 dB odB: 0.175 Vll KHz 4 Frequency response Hz Signal to noise ratio dB >65 >60 Levell 0 dB: 2.0 Vll KHz 5 Levell 0 dB: 2.0 Vll Input: Short dB >45 >40 6 Channel separation KHz - - Frequency 1 KHz 7 Input
Resumen del contenido incluido en la página 12
www.delphLcom and for all products for the remainder of the limited warranty period, you must contact Delphi by phone at 1.877.GO DELPHI [1.877.463.3574). Iffurther clarification or additional information is required from Delphi, you may call Delphi at 1.877.GO DELPHI (1.877.463.3574) . If warranty service is needed at any time during the warranty period, the purchaser will be required to furnish a sales receipt/proof of purchase indicating the date of purchase, amount paid. and place of purchas
Resumen del contenido incluido en la página 13
user DE:LPHI gUlde SA10175 o 9 XM Satellite Radio Receiver ((.~o») Important: This manual contains importllntsafetyand operating information. Please read.underst/llnd.llnd follow tl'lc! lnstructlol'\S In this manual. FailuRe ttl do so could I'QSUlt In pl!rSOI'IsllnJury,dClath,.ancl/ordamagCl tel your roadyXT. Iccessorles.andlor to your vehlde or property. A
Resumen del contenido incluido en la página 14
FCC ID: RS2SA10177 IC: 5697A-SA10177 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. ® The Delphi XM roadyXT Satellite Radio Receiver incorpo- rates an FM transmitter and is therefore classified as an intentional transmitter. Changes or modifications to the unit not expre
Resumen del contenido incluido en la página 15
Table of Contents 3 T Table of Contents able of Contents A Brief History · · · · · · · · · · · · · · · · · · · · · · · · · 4 Audio level · · · · · · · · · · · · · · · · · · · · · · · · · · · 17 About Delphi· · · · · · · · · · · · · · · · · · · · · · · · · 5 Aiming the antenna · · · · · · · · · · · · · · · 18 ™ About XM· · · · · · · · · · · · · · · · · · · · · · · · · · · · · 5 TuneSelect · · · · · · · · · · · · · · · · · · · · · · · · · · 18 Stock Ticker · · · · · · · · · · · · · · · · · · · · ·
Resumen del contenido incluido en la página 16
A Brief History 4 A Brief History The new Delphi roadyXT Satellite Radio Receiver—smaller, lighter, and ® more versatile than the best-selling Roady2 . • Dock your roadyXT into cradles that are easily installed in your vehicles or your home. One simple motion connects your roadyXT’s power, audio, and antenna. • A built-in FM transmitter allows you to hear XM programming on any nearby FM radio, using any unused frequency on the FM band. • Exclusive Info Extras and Stock Ticker bring you persona
Resumen del contenido incluido en la página 17
A Brief History 5 About Delphi Delphi is a worldwide leader in mobile electronics, vehicle components, and audio technology. Delphi created the first in-dash car radio in 1936 and continues its strong tradition of innovation in the audio industry. Now Delphi technology has helped make satellite radio a reality, and Delphi con- tinues to expand its in-vehicle and consumer electronics technologies. With its exciting line of satellite radio products, Delphi offers a broad portfolio of products to a
Resumen del contenido incluido en la página 18
Let’s Get Started 6 Let’s Get Started First, some important reminders We know you’re eager to turn on your new roadyXT and listen to XM. Please take a moment to remember the following: Warning: This manual contains important safety Caution: Use your roadyXT only with the enclosed and operating information. Please read, understand, and components or approved accessories. Do not modify follow the instructions in this manual. Failure to do so wires or other connectors in any way; you could cause co
Resumen del contenido incluido en la página 19
Let’s Get Started 7 Controls power menu – access advanced features up and down arrows, and configuration select – change chan- options nels, choose menu ™ options, TuneSelect disp – change search – look up channels what you see on by category or scan all the display channels pre/dir – select memory – save jump – return to numbers – enter a between direct and recall up to previous channel; channel directly or channel entry or 20 artist names press and hold to select favorite presets up to 30 pres
Resumen del contenido incluido en la página 20
Let’s Get Started 8 Display signal strength – search by scanning display search channels channel selection 1 to 3 bars all channels modes 1-5 by category mode – direct entry or preset banks A, B, or C additional info – channel name, channel number, artist, song title, Stock Ticker, and Info Extras
