Lucent Technologies MDW 9030Pの取扱説明書

ページ1に含まれる内容の要旨

MDW 9030P Wireless
Pocketphone Quick Reference
503-801-161
Comcode 107993149
Issue 2
March 1997

ページ2に含まれる内容の要旨

MDW 9030P Wireless Pocketphone Quick Reference Handset Controls Receiver Headset On/Off Receives the sound Press to turn the headset on of your caller's voice, if the headset is plugged in. unless a headset is ON appears in handset connected. display. To turn off, press again. Turn on to make or Antenna answer a call, and turn off to Extend fully to “hang up.” maximize the handset range and voice Lanyard Loop quality. Attach lanyard for carrying handset. Handset Display Displays status of Volum

ページ3に含まれる内容の要旨

Handset Display 3 4 5 6 1 2 RANGE MUTE 7 MSG ON 9 8 1 Information you would see on a wired system phone's display, (except time), based on your communications system: LCL:P, D, M1, or M2= Local Mode:communications system WIRELESS TEST=Handset in Wireless Test Mode VIBR=Vibrator enabled PSEL=Line Preselection enabled PRESELECTION:ON / OFF=Line Preselection Mode:status CHANGE BUTTN MAP=Communications system setting is wrong MAP:P, D, M1, M2=Button Mapping Mode: setting NO LINK=Handset is not commu

ページ4に含まれる内容の要旨

Volume Adjustment To increase or decrease the volume of the handset alerter or the receiver (earpiece): n Alerter: Press the "+" or the "–" button while the MDW 9030P is awake but turned off. If the display is dark (the phone is in "sleep" mode), press " to wake it up, then press the "+" or the "–" button. n Receiver: Press the "+" or the "–" button while the MDW 9030P is turned on. Battery Charger LEDs The color of the battery charger's LEDs indicates the state of the corresponding battery p

ページ5に含まれる内容の要旨

Making a Call 1. Press O. 2. If desired, press " to move the Selection rectangle; then press ' corresponding to the line you want. 3. Dial the call. 4. To end the call, press O. Answering a Call 1. Press O. 2. Speak into the handset. 3. To end the call, press O. Preselecting a Line or Button Once Line Preselection is enabled, proceed as follows: 1. If the display is blank, press ". 2. If necessary, press " to move the Selection rectangle. 3. Press ' corresponding to the line or button you want.