ページ1に含まれる内容の要旨
,
DISHWASHER
EN
EN
-
(
Positioning and levelling
Connecting the water and electricity supplies
Technical data
Overall view
Control panel
Lower rack
Cutlery basket
Upper rack
!
Starting the dishwasher
Loading the detergent
Washing options
"
#
$
Wash cycle table
%
&
Loading the rinse aid
Loading the refined salt
'
(
ページ2に含まれる内容の要旨
Keep this instruction manual in a safe place for
/
-. future reference. If the appliance is sold, given away or moved, please ensure the manual is kept with the • To a suitable cold water connection point: before machine, so that the new owner may benefit from the attaching the hose, run the water until it is advice contained within it. perfectly clear so that any impurities that may be present in the water do not clog the appliance; Please read thi
ページ3に含まれる内容の要旨
/ -. Connect the outlet hose (without bending it) to a replaced by authorised technicians only. drain duct with a minimum diameter of 4 cm. The Company shall not be held responsible for any Alternatively, rest it over a sink or tub; the free end incidents that occur if these regulations are not of the hose should not remain immersed in water. observed. The special plastic A 0+
/ # elbow* makes it easier to find the best layout: fix
ページ4に含まれる内容の要旨
As the colours of the wires in the mains lead may -. If your appliance is supplied with a 13 amp. fused not correspond with the coloured markings plug it can be plugged into a 13 amp socket for identifying the terminal in your plug, proceed as immediate use. Before using the appliance please follows: read the instruction below. connect Green & Yellow wire to terminal market “E E E E E” or coloured Green or Green & Yellow. Warning Warning Warning Warning Warning:this ap
ページ5に含まれる内容の要旨
4+ +
/ -. (5 Upper rack 5 Upper sprayer arm 5 Tip-up compartments 5 Rack height adjuster 5 Lower rack 1 5 Lower sprayer arm 3 4 !5 Cutlery basket 2 $5 Washing filter &5 Salt dispenser ()5 Detergent and rinse aid dispensers ((5 Data plate 5 6 7 9 8 10 11 - .( 4" 0 0%7%- - 4.7411 4.7411 %-0..8 indicator indicator light* button button indicator indicator lights light* light "0 36- .*%48%- indicator light Selector knob: "0
ページ6に含まれる内容の要旨
Before loading the rack, remove all food residue from the stops (see figure). -. crockery, leave saucepans and frying pans with burnt-on If the rack is equipped with the click residue to soak and empty all remaining liquid from cups and clack handles* (see figure), pull glasses. After loading the appliance, check that the sprayer them upwards or downwards to arms can rotate freely. adjust the height. / Arrange the more difficult items to wash using the Loading exampl
ページ7に含まれる内容の要旨
/
-. 1. Turn the water tap on. A successful wash also depends on the correct amount of 2. Press the ON/OFF button: the indicator light will illuminate. detergent being used, as recommended by the manufacturer. 3. Open the door and pour in a suitable amount of detergent Exceeding the recommended amount does not result in a (see below). more effective wash and pollutes the environment. 4. Load the racks (see Loading the racks) and shut t
ページ8に含まれる内容の要旨
" # " # , INDESIT dishwashers are equipped with an automatic filter cleaning system so that they do not become -. clogged with food residues. This function may extend the duration of the wash cycles. If there is a high level of dirt contained in the filters, the dishwasher will stop operating (see Troubleshooting - Blocked filter alarm). Wash Detergent cycle (A) = compartment A Wash cycle selection Wash cycles (B) = compartment B Pre-wash Drying duration instructions (tole
ページ9に含まれる内容の要旨
%
Only use products that have been specifically when the green float* cannot be seen by simply -. designed for dishwashers. looking at the cap of the salt dispenser; Do not use table salt or industrial salt. when the LOW SALT* indicator light on the panel flashes; If using a multi-functional product (2-in-1, 3-in-1, 4-in-1) if your machine is not equipped with an indicator it is not necessary to add rinse aid; however, we light or a green float: recommend that
ページ10に含まれる内容の要旨
'
/
#
-.
The filters remove food residue from the water used Turn off the water tap after every wash cycle to in the wash cycle: to obtain the best results from avoid leaks. each wash, they should be cleaned. Remove the plug from the socket when cleaning Clean the filters regularly. the machine and when carrying out maintenance work. After cleaning check that the filter assembly has been replaced correctl
ページ11に含まれる内容の要旨
*
+
The appliance was designed and manufactured in Consumers should contact their local authority or -. compliance with current international safety retailer for information concerning the correct standards. The following information has been disposal of their old appliance. provided for safety reasons and should therefore be read carefully. +
#
8 # +
' The appliance was designed for domestic use +
/ # insid
ページ12に含まれる内容の要旨
,
09/2005-Xerox Business Services Whenever the appliance fails to work, check for a solution from the following list before calling for Technical -. Assistance Centre.
2 *
, 7
2
/ 5 The plug has not been inserted into the electrical socket properly, or there is no power in the house. The dishwasher door has not been shut properly. A delayed start has been programmed (see Start-up
