ページ1に含まれる内容の要旨
TM
Aussie Adventurer
PORTABLE LP Gas Grill
Pre-Assembled Grill
Owner’s and Use Manual
This Owners Manual for use with Models:
2400 with Side Table
2410 with Side Burner
2420 with Side Table and Lantern
2430 with Side Burner and Lantern
2440 with Side Burner, Lantern and Carry Bag
MODEL 2430 shown
(LP Cylinders not included)
FOR OUTDOOR HOUSEHOLD USE ONLY. NOT FOR COMMERCIAL USE.
For Customer Service, call 1-800-251-7558 or visit our website at www.meco.net
• Failure to follow these instruc
ページ2に含まれる内容の要旨
CONTENTS I. Assembly Instructions.......................................................2 3) Performing a Leak Test............................................12 A) Parts Illustrations...........................................................3 B) Lighting the Gas Grill.................................................13 B) Parts List........................................................................4 1) Ignition Lighting Main Grill........................................13 C) Setting up Yo
ページ3に含まれる内容の要旨
Parts Replacement Illustrations 1 6 3 5 2 4 7 11 8 10 9 13 12 15 14 20 16 19 18 17 21 23 25 24 22 26 30 27 28 31 29 36 37 35 32 34 33 39 40 42 38 41 3
ページ4に含まれる内容の要旨
46 47 43 45 44 50 51 48 49 58 52 56 55 53 54 57 59 60 62 61 QTY MODEL MODEL MODEL MODEL MODEL PARTS LIST 2400 2410 2420 2430 2440 ITEM DESCRIPTION PART # 1 Owner's Manual 03.6506.00 1 1 1 1 1 2 Hood w/Hinges 03.6506.01 1 1 1 1 1 3 Screw, M6x9 Shoulder (Hood Hinge) 03.6506.02 2 2 2 2 2 4 Hinge, Hood 03.6506.03 1 1 1 1 1 5 Screw, M5x10mm (Hood Hinge Bracket) 03.6237.00 3 3 3 3 3 6 Nut, M5 Hex Washer Head (Hood Hinge) 03.6506.04 3 3 3 3 3 7 Screw, M5x15 (Hood Handle) 03.6506.05 2 2 2 2 2 8 Hood Ha
ページ5に含まれる内容の要旨
QTY PARTS LIST (CONT'D) MODEL MODEL MODEL MODEL MODEL 2400 2410 2420 2430 2440 ITEM DESCRIPTION PART # 29 Heat Shield 03.6506.27 1 1 1 1 1 30 Screw, ST3.8x6mm (Heat Shield) 03.6506.28 2 2 2 2 2 31 Guide Bracket, Main Burner 03.6506.29 1 1 1 1 1 32 Screw, M4x10mm (M. Burner/S. Burner Electrode) 03.6506.30 4 4 4 4 4 33 Main Burner 03.6506.31 1 1 1 1 1 34 Wire, Main Burner Ground 03.6506.32 1 1 1 1 1 35 Nut, M4 Hex (Main Burner/Ground Wire) 03.6506.33 2 2 2 2 2 36 Piezo 03.6260.01 1 2 1 2 2 37 Ele
ページ6に含まれる内容の要旨
STEP 2) Lift grill up at one leg mount. Release the spring lever at each leg foot. (FIG. 2A) Swing each leg all the way out one at a time, and let it rest on the floor. (FIG. 2B, 2C & 2D) The last leg will allow the grill to stand by itself. This is the lower height for use. Leg Pinch area FIG. 3B 1 1’4” FIG. 3D FIG. 3C Depress Leg Button Spring Lever STEP 4) If the grill is not standing level, the legs can be adjusted to level it. There are 3 adjustments FIG. 2A within a range of 1 1/4” from t
ページ7に含まれる内容の要旨
Lift Bowl Pan and Burner up and out Control Knob Stryofoam Pads Pull hose away FIG. 5A from flange Fig. 4B To reduce the risk of serious bodily injury or death: · Do not load plastic side table or side burner with more than 10 lb./4.5kg (one gallon liquid/3.8L). Excess weight could tip grill over causing a fire or explosion and damage side table or side burner. · Do not place hot utensils or cookware on plastic side table or side burner cover that can cause them to melt. SIDE TABLE ASSEMB
ページ8に含まれる内容の要旨
Insert the large opening of the Mantle over the STEP 3) Hook Side burner. (FIG. 6B) NOTE: The colored end should Burner Grid into far be at the top. Pull the mantle down over the burner left hole in side table until the large opening encircles the two bottom and lower two wires burner notches and the top opening encircles the into the other two two top burner notches. (FIG. 6C) Form the mantle holes. (FIG. 5E) to a conical shape around the burner. (FIG. 6D) NOTE: Do not tear a hole in the mantle
ページ9に含まれる内容の要旨
STEP 3) Assemble Lantern and Gas Tube: Insert the gas tube into the lantern nozzle. (FIG. 7A) To reduce the risk of serious bodily injury or death: Engage the knurled coupling into the lantern and · Always burn portable lantern on a flat level surface in turn until snug. (FIG. 7B) Be careful not to cross an upright position away from any flammable thread the connection. substances. · When carrying Portable Lantern, hold it away from you and do not run with it. · Do not use gas tube with Lant
ページ10に含まれる内容の要旨
Connecting/Disconnecting LP Gas Cylinders INSTALLATION CODES HOSES AND REGULATOR To reduce the risk of serious bodily injury or death: To reduce the risk of serious bodily injury or death: · Use only the hose and regulator assembly that have · This installation must conform with local codes or, in been supplied with this gas grill. Do not use hose the absence of local codes, with either the National and regulator from another manufacturer. Fuel Gas Code, ANSI Z223.1, or CAN/CGA-B149.2, · A
ページ11に含まれる内容の要旨
STEP 3) Connect 1 pound Cylinder to Grill and Accessories: Grasp the regulator to the grill (FIG. 10B), Side burner hose coupling (FIG. 10C), or Lantern gas supply tube (FIG. 10D) with one hand. Hold Cylinder upright with other hand. Push cylinder nozzle into the threaded connection and turn cylinder by hand until snug. Do not turn Cylinder upside down. Do not use tools. Make sure the connection does not cross thread. Swing Cylinders into Leg Holders and snap into place. (FIG. 10E) Leg FIG. 10B
ページ12に含まれる内容の要旨
PERFORMING A LEAK TEST Leak Test Main Burner Connections To reduce the risk of serious bodily injury or death: · Always perform a leak test before each use. · Never use a match or open flame to test for gas leaks. · Perform a leak test in a well ventilated area. · Do not perform a leak test on a grill while it is hot or in use. · Do not use the LP gas grill if you detect a gas leak that cannot be corrected by using the leak test procedures on following page. How to perform a leak test: Supp
ページ13に含まれる内容の要旨
LIGHTING THE GAS GRILL To reduce the risk of serious bodily injury or death: · Use only 1 pound LP cylinder with this Grill. · Open Hood before lighting the grill to prevent an explosion from gas build-up. · Make sure there are no obstructions to the flow of combustion and ventilation air to the main grill. · During failed lighting attempts, or if the side burner goes out during the cooking process, turn control knob “Off” to dissipate any accumulation of gas. Wait five minutes before repeatin
ページ14に含まれる内容の要旨
To reduce the risk of serious bodily injury or death: · Use only 1 pound LP cylinder with Side Burner. · Remove plastic Side burner cover before lighting the Side burner to prevent an explosion from gas build-up or melting of the cover. · Make sure there are no obstructions to the flow of combustion and ventilation air to the side burner. · During failed lighting attempts, or if the side burner goes out during the cooking process, turn control knob “Off” to dissipate any accumulation of gas. Wa
ページ15に含まれる内容の要旨
To reduce the risk of serious bodily injury or death: · Always light and use lantern outdoors. Never use · Use only 1 pound LP cylinder with Lantern. indoors, on recreational vehicles, or boats. · Do not use gas tube with Portable Lantern and 1 pound · To avoid eye damage, do not stare into the intense light. LP cylinder. It is unstable and will cause lantern to tip · Never operate lantern with a hole in the mantle or over and cause a fire. overheating and fire hazard could result. · Make sure
ページ16に含まれる内容の要旨
· Always disconnect LP gas cylinder when not in use. OPERATING THE LP GAS GRILL Allow grill to cool before handling parts or cleaning. · Remove grill covers and store at least 36 inches from the LP gas grill while in use. Grill covers are made of a flammable material. Allow the grill to completely To reduce the risk of serious bodily injury or death: cool before putting the cover back on the grill. · Never use charcoal in your LP gas grill. Do not use GRILL COOKING aerosols or store fla
ページ17に含まれる内容の要旨
To re-install the Bowl Pan, be sure to locate the indents END OF COOKING SESSION on the (4) Bowl Pan posts and re-connect the electrode wire. 5) Lantern-Wipe clean the lantern housing, globe and top cap with a mild detergent and soft cloth. Do not use abrasive · To avoid burns, allow the grill and the grease in the cleaners that will scratch the housing. grease container to cool before emptying, handling 6) Burners-Clean the Burners annually, or whenever heavy parts or cleaning. bui
ページ18に含まれる内容の要旨
f) If grill is to be stored, coat Burner lightly with cooking oil Clear Clogged Port and wrap in a protective cover to keep insects out. Holes with small nail B) Lantern Burner: or Wire a) Remove the top cover and glass globe. Open up clogged burner holes with a small nail or wire. (FIG. 19A) Normal wear and corrosion could enlarge some holes, however, if large cracks or holes are found, replace the Burner. Note: It is normal for surface rust to be present on the burners. b) Remove the two
ページ19に含まれる内容の要旨
STORAGE AND TRANSPORT To reduce the risk of serious bodily injury or death: · Disconnect all LP gas cylinders when not in use and before storage. Gas will vent from lantern gas tube and side burner. Make sure you disconnect cylinders away from you to avoid gas fumes and odor in your face. · Store your LP gas grill in a cool, dry place. You can Tuck hose store your grill indoors only if the cylinders are loop into disconnected. flange · Do not store an LP cylinder indoors (empty or filled).
ページ20に含まれる内容の要旨
e) Unzip the Grill Cover and lay it out flat as shown. Lantern in pocket (FIG. 19E) With grill legs folded under the grill, place the grill on the grill cover. f) Unzip the pocket in the grill cover and place Lantern inside as shown. (FIG. 19F) Zip the Lantern pocket. g) Carefully fold over the grill cover flap, allowing the Lantern to rest on top of the body above the left leg. Zip the grill cover and allow the handle to protrude through the opening of the grill cover. The grill can be tr
