ページ1に含まれる内容の要旨
Model OFD-614
5/4/2006
Patents Pending
Thank you for purchasing the Oracle
FrontDoor Unit. This product has been
Oracle(tm)
designed and manufactured in the USA,
One year limited WARRANTY
utilizing the highest quality standards
available.
FrontDoor™
International Electronics Inc. (IEI) warrants this product to be free of defects in materials and
workmanship, for one year. For a period of ONE YEAR following purchase, IEI will repair or
No Wiring or Trenching
replace the product fr
ページ2に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending Preface MOUNTING TEMPLATE General Information………………………………………….………….….….3 Parts Supplied……………………………………………………………….....3 (Use this template as a guide for mounting screw placement) . Section 1 – Installation 1.1 Installing the Oracle FrontDoor (OFD)…………………….……...4 A. Installing the OFD with screws……………...……………..…4 B. Installing the OFD with mounting tape………...………..…...4 1.2 Installing the Batteries………………………………………...…….5 Section 2 – Activation 2.1 Act
ページ3に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending The Oracle (OFD) is designed for use as a Wireless Doorbell By switching dipswitch #4 UP (away from the circuit board), you can set the Indoor/Outdoor FrontDoor Intercom’s volume to be louder. and Intercom for residential, as well as commercial applications. It is designed to tolerate severe outdoor conditions of -40 to +85 C, as well as high humidity and condensation. Since this intercom system requires no 5.2 ADJUSTING MICROPHONE SENSITIVITY c
ページ4に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending Make sure that the “CALL” button is in easy reach of a visitor. The unit may be mounted with NOTE: If the Repeater Units have not been previously activated to either the included screws or the included double-sided high strength tape. anything within an existing network, please follow the directions found in the Oracle Wire-free Repeater product manual. A. MOUNTING THE OFD WITH SCREWS To mount the FrontDoor, use the included mounting template (
ページ5に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending Note: If used in location that will be below -10°C (20°F) Lithium batteries are recommended. To set a FrontDoor unit to Passive Mode, switch dipswitch #1 UP (away from the circuit board). Note: Any Intercoms that had been taught to this unit will have to have their memory cleared 2.1 ACTIVATING AN INTERCOM NETWORK and be re-taught to the Active Unit in the network as if they were newly installed. The FrontDoor must be taught to an interco
ページ6に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending channel lights start flashing quickly). Note: Both steps 1 & 2 must occur within 20 seconds of each other. 2. Press and release the LEARN button on the activated Oracle Intercom or Flush Mount Unit. 1. Using the phone that is connected to the OTIU, once you hear a dial tone press: 3. Proceed to Section 3 "BEEP" 0 7 * * Hang up and the LEARN light will flash for up to 15 seconds. If it does not and you 2.3
ページ7に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
ページ8に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
ページ9に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
ページ10に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
ページ11に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
ページ12に含まれる内容の要旨
Model OFD-614 5/4/2006 Patents Pending
