ページ1に含まれる内容の要旨
CEMENT MIXER
6 CU. FT.
Model 45198
OPERATING INFORMATION
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
© ®
Copyright 2001 by Harbor Freight Tools . All rights reserved. No portion of this manual
or any artwork contained herein may be reproduced in any shape or form without the ex-
press written consent of Harbor Freight Tools.
For technical questions please call 1-800-444-3353
REV 01/02
ページ2に含まれる内容の要旨
SPECIFICATIONS TABLE Weight 690 lb. Capacity 6 Cubic Feet Drum Diameter 28” Pneumatic Wheel Diameter 12” Barrel Pulley 14.5” Gas Engine HP 7.5 HP Gas Engine Pulley 3” Gas Engine Speed 3,600 RPM 20 RPM (Low speed to keep cement from setting) Drum Speeds 36 RPM (Maximum speed for heavy mixing) Less than 25 MPH Towing Speed NOT TO BE TOWED ON PUBLIC ROADS OR HIGHWAYS. SAVE THIS MANUAL You will need this manual for the safety warnings and precautions, operating, mainte- nance and cleaning procedures
ページ3に含まれる内容の要旨
6. DRESS SAFELY. Nonskid footwear or safety shoes should be used when work- ing with this product. Do not wear loose clothing or jewelry as they can become caught in moving parts. Wear a protective hair covering to prevent long hair from becoming caught in moving parts. 7. INDUSTRIAL APPLICATIONS MUST FOLLOW OSHA REQUIREMENTS. 8. DO NOT OVERREACH. Keep proper footing and balance at all times to prevent tripping, falling, back injury, etcetera. 9. STAY ALERT. Watch what you are doing at a
ページ4に含まれる内容の要旨
2. PRIOR TO USING THE CEMENT MIXER, MAKE SURE YOU READ AND COM- PLETELY UNDERSTAND THIS INSTRUCTION MANUAL AND THE GAS EN- GINE MANUFACTURER’S INSTRUCTION MANUAL. 3. USE COMMON SENSE WHEN HANDLING GASOLINE. Transport gasoline only in approved safety containers. Do not refuel the Gas Engine with the Engine running or while it is hot. Do not smoke when refueling the Engine. Wipe up any fuel spills on the Engine. Do not operate the Cement Mixer if there is evidence of a fuel leak. Do not
ページ5に含まれる内容の要旨
OPERATING INSTRUCTIONS NOTE: All parts below refer to the parts listed and shown on pages 8 and 9 of this manual. 1. CAUTION: Do not attempt to move the Cement Mixer when it is full and/or in operation. 2. Place the Cement Mixer on a solid, flat, and level surface that is capable of sup- porting the weight of the mixer and it’s load. 3. Start the Engine (45), and allow it to reach the appropriate operating temperature as instructed in the Engine manufacturer’s operating manual. 4. NOTE: Fi
ページ6に含まれる内容の要旨
9. To discharge the cement mix, grasp the Hand Wheel (51) firmly with one hand and release the Brake Handle (60). Then, slowly turn the Hand Wheel counter- clockwise to empty the Drum (4). CAUTION: To prevent accidental discharge of the cement mix, do not release the Brake Handle without holding the Hand Wheel firmly. Always make sure the Brake Handle is fully engaged after discharging the concrete mix and before refilling the Drum. (See Assy. Diagram.) 10. After discharging the cement
ページ7に含まれる内容の要旨
MAINTENANCE AND CLEANING 1. CAUTION: Never perform any services or maintenance on the Cement Mixer while it is running. Before performing services or maintenance, turn off the en- gine and disconnect the spark plug wire to prevent accidental starting. 2. Before each use, inspect the general condition of the Cement Mixer. Check for loose screws, misalignment, binding of moving parts, loose or broken parts, and any other condition that may affect its safe operation. If abnormal noise or vib
ページ8に含まれる内容の要旨
PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIA- GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFAC- TURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY RE- PAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD B
ページ9に含まれる内容の要旨
PARTS LIST SKU 45198 For technical questions, please call 1-800-444-3353. Page 9
ページ10に含まれる内容の要旨
ASSEMBLY DIAGRAM NOTE: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. SKU 45198 For technical questions, please call 1-800-444-3353. Page 10
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
ページ20に含まれる内容の要旨
