Milnor KXMIC00155の取扱説明書

ページ1に含まれる内容の要旨

Published Manual Number/ECN: H000000013/99462N
• Publishing System: TPAS
• Access date: 1/18/01
• Document ECN's: Latest Available
Kit Instruction—
KXMIC00155
PELLERIN MILNOR CORPORATION POST OFFICE BOX 400, KENNER, LOUISIANA 70063-0400, U.S.A.

ページ2に含まれる内容の要旨

Please Read About the Manual Identifying Information on the Cover The front cover displays pertinent identifying information for this manual. Most important, are the published manual number (part number) /ECN (date code). Generally, when a replacement manual is furnished, it will have the same published manual number, but the latest available ECN. This provides the user with the latest information applicable to his machine. Similarly all documents comprising the manual will be the latest availa

ページ3に含まれる内容の要旨

HXMIC00155 INSTRUCTIONS FOR KIT KXMIC00155 1) Save the current memory in a data storage device. 2) Remove the video card from the video interface board. 3) Remove the processor, memory board and ribbon cable from the machine. 4) Remove the EPROMS from the old processor and memory board. 5) Install the EPROMS in the new processor board according to the tag. 6) Mount the video card bracket on the processor board using the metal screws. 7) Install the new processor board in the machine, you may nee

ページ4に含まれる内容の要旨

CABLE TO MONITOR BBVI NOTES: J1 INTERFACE 1.EPROMS MUST BE INSTALLED IN BOARD THE CORRECT SOCKET FOR THE MACHINE TO OPERATE. THE TOTAL W1 EDGE CARD NUMBER OF EPROMS MAY VARY. CONNECTOR EACH EPROM IS NUMBERED 1,2,ETC a. IF THERE IS 1PROM-INSTALL IN BPB SOCKET IC29. PROCESSOR BOARD b. IF THERE ARE 2 EPROMS-INSTALL EPROMS MUST BE #1 EPROM IN SOCKET IC30 AND #2 IC29 INSTALLED WITH NOTCH EPROM IN SOCKET IC29. IN POSITION IC30 c. IF THERE ARE 3 EPROMS-INSTALL SHOWN. IC63 #1 EPROM IN SOCKET IC63, #2 IN