ページ1に含まれる内容の要旨
SY-P4I865PE Lite
DRAGON 2
Motherboard
Quick Start Guide
Intel USB2.0 The SOYO CD Quick BIOS Hardware Introduction
Driver Setup Installation
Installation
ページ2に含まれる内容の要旨
SOYO™ 1. Please read the users guide before proceeding with your installations. Serious damage may occur if the procedure is not followed properly. 2. This motherboard does not support CPUs with a Vcore higher than 1.6 volts. Please make sure the CPU you are using 1.6 volts or below. Check the CPU specification before you insert it in the CPU socket. 3. AGP cards running at 3.3v are not supported. Only AGP cards running at 1.5v (most 4x or 8x AGP cards) are supported on this mainboa
ページ3に含まれる内容の要旨
SOYO™ SY-P4I865PE Lite DRAGON 2 Motherboard mPGA Socket 478 processors Intel 865PE AGP/PCI Motherboard 400/533/800 MHz Front Side Bus supported ATX Form Factor Copyright © 2003 by SOYO Computer Inc. Trademarks: SOYO is a registered trademark of SOYO Computer Inc. All trademarks are properties of their owners. Product Rights: All names of the product and corporate mentioned in this publication are used for identification purposes only. The registered trademarks and copyrights belo
ページ4に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 1 Introduction 1 Congratulations on your purchase of the SY-P4I865PE Lite DRAGON 2 Motherboard. This Quick Start Guide illustrates the steps for installing and setting up your new Motherboard. This guide provides all users with the basic steps of Motherboard setting and operation. For further information, please refer to the SY-P4I865PE Lite DRAGON 2 Motherboard User's Manual that came with your Motherboard. Unpacking When unpacking the
ページ5に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide SY-P4I865PE Lite DRAGON 2 Motherboard Layout DDR_A1 DDR_A2 DDR_B1 PS/2 KB P PS S//2 M 2 Mous ouse e Connector Connector USB COM A COM B PRT +12V Power USBLAN ATX Power MIC IN / Center & Bass out Audio out / Front out IDE 2 IDE 1 AGP Slot Audio in / Rear out J30 FDC1 6 5 DAVICOM 2 1 DM9102AE AC97 PCI Slot #1 codec JP5 CMOS Clear PCI Slot #2 Jumper 1 4 1 4 SATA2 3V PCI Slot #3 CDIN1 Lithium AUX_IN1 SATA1 Battery PCI Slot #4 ITE IT8712F PCI Slot #5
ページ6に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Key Features Supports Intel® mPGA Socket 478 processors : Pentium® 4 with and without Hyperthreading, Northwood, Prescott (400/533/800MHz FSB) Pentium® 4 Celeron SOYO COMBO Setup CMOS setup menu for CPU complete and easy changing of your CPU settings in CMOS setup, making jumpers obsolete. Note: CPU with higher than 1.6 volts are not supported. Intel® 865PE / ICH5 Chipset Chipset The SY-P4I865PE DRAGON 2 supports PC2700 and PC3200 DD
ページ7に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide ICH5 integrated Serial ATA controller supporting up to 2x UDMA 150 hard disks Storage ICH5 Integrated Parallel ATA controller supporting up to 4x UDMA 33/66/100 Parallel ATA devices. 8x USB 2.0 compliant ports (4 on rear IO panel, 4x USB 2.0 motherboard connectors. Onboard AC97 6 channel Audio Codec Sound Onboard 10/100 Mbps 100Base-T Ethernet controller, Network supporting Wake-On-Lan (WOL) Power Failure resume function to allow the
ページ8に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 2 Installation 2 To avoid damage to your Motherboard, please follow these simple rules while handling this equipment: Before handling the Motherboard, ground yourself by touching on to an unpainted portion of the system's metal chassis. Check the mainboard for damage. If any component appears to be loose or damaged contact our customer service center immediately. Follow the directions in this section which are designed to help you use a
ページ9に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Install the Motherboard We will now begin the installation process. Please follow the following procedure to lead you to a complete and correct installation. Step 1- Install the Central Processing Unit (CPU) Step 2- Install memory modules Step 3- Connect cables, case wires, power supply and install expansion cards Step 4- Install expansion cards Step 1. Install the CPU ® CPU Mount Procedure: To mount the Pentium 4 Socket mPGA478 process
ページ10に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Configure Memory This motherboard supports one Dual Channel to your memory. Note that you can use normal DDR memory for Dual Channel to work. Also note that for Dual Channel to work 2 modules of equal size and specifications have to be installed. The largest memory capacity possible is 3GB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed. Note that when installing 3GB of memory, your total memory will be
ページ11に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Step 2. Connect cables, case wires, and power supply This section tells how to connect internal peripherals and the power supply to the Motherboard. The internal peripherals consist of IDE devices (HDD, CD-ROM, etc), Floppy Disk Drive, Chassis Fan, Front Panel Devices (ACPI LED, Internal Speaker, Reset Button, IDE LED, and KeyLock Switch.), Wake-On-LAN network card, VGA card, Sound Card, and other devices. For more details on connecting intern
ページ12に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Connectors and Plug-ins CPU Cooling Fan: CPUFAN1 Chassis Fan: CHAFAN1 Pin1 Pin2 Pin3 Pin1 Pin2 Pin3 GND +12V Sensor GND +12V Sensor Standard IrDA (Infrared Device Header): SIRCON Chassis Fan: CHAFAN2 Pin1 Pin2 Pin3 Pin1 Pin2 Pin3 Pin4 Pin5 VCC NC IRRX GND IRTX GND +12V NC CD-IN AUX_IN1 Pin1 Pin2 Pin3 Pin4 Pin1 Pin2 Pin3 Pin4 Left GND GND Right Left GND GND Right MIC & LED Connector: J30 Pin1 Pin2 Pin3 Pin4 Pin5 Pin6 Line_Out_L Line_Out_R
ページ13に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Power On/Off: PWRBT Connect your power switch to this header (momentary switch type). To turn off the system, press this switch and hold down for longer than 4 seconds. ATX 12V Power Supply: ATX PW Attach the ATX 12V Power cable to three connector. (This motherboard requires an ATX 12V power supply, an AT or ATX power supply can NOT be used.) When using the Power-On by Keyboard function, please make sure the ATX power supply is able to provide
ページ14に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Please install the ATX power according to the following pin assignment: ATX Power Pay special care to the directionality. 12V 5V Pin1 Pin3 5VSB 5V PW-OK -5V COM GND GND 5V GND +12VDC GND GND 5V PS-ON GND GND +12V Power Connector 3.3V -12V 3.3V 3.3V FIG . 2 FIG . 1 Step 3. Install expansion cards The motherboard has 1 AGP slot and 5 PCI slots. 1. Read the instruction document of the related expansion card before inserting th
ページ15に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide This motherboard only support 1.5V AGP card (4X/8X card). If 3.3V AGP card is used, the system will not boot-up and the AGPDET LED will lit. (1.5V only) AGP Slot (When AGPDET LED lit, it means 3.3V AGP card is used.) If use 3.3V AGP c a rd,the system will not power on and the AGPDET LED will lit. CMOS Clear (JP5) In some cases the CMOS memory may contain wrong data, follow the steps below to clear the CMOS memory. 1. Clear the CMOS memory by mom
ページ16に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Audio Speakers connections When using 2-channel speaker, connect the speaker cable to line-out. If you’re using 4 channel speaker, connect the front L/R speakers to line-out and rear L/R speakers to Line-in. make sure to set the Audio Rack software for 4 channel speaker system. Do not forget to set the Audio Rack software to 4-channel system. If you are using 6 channel speaker, connect the front L/R speaker to line out, rear L/R speaker to lin
ページ17に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide Onboard LAN LED Definition When this LED is lit, this This is the LAN activity & link means the LAN is running LED. It will blink when it is at 100 mbps, if it is not lit, active. the Onboard LAN is working at 10 mbps. 17 Hardware Installation
ページ18に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 3 Quick BIOS Setup 3 This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead, CPU settings are software configurable with the BIOS [SOYO COMBO FEATURE]. The [SOYO COMBO FEATURE] combines the main parameters that you need to configure, all in one menu, for a quick setup in BIOS. After the hardware installation is complete, turn the power switch on, then press the key during the system diagnostic checks to
ページ19に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide 4 The SOYO CD 4 The SOYO-CD will Auto Run only in Windows Based Operating Systems. Your SY-P4I865PE Lite DRAGON 2 motherboard comes with a CD-ROM labeled “SOYO CD”. The SOYO CD contains a. The user’s manual for your new motherboard in PDF format, b. The driver software necessery for installation, and c. A database in HTML format with information on SOYO motherboards and other products. Step 1. Insert the SOYO CD into the CD-ROM drive If
ページ20に含まれる内容の要旨
SY-P4I865PE Lite DRAGON 2 Quick Start Guide The user's manual files included on the SOYO CD are in PDF (Postscript Document Format). In order to read a PDF file, the appropriate Acrobat Reader software must be installed in your system. Note: The Start Up program automatically detects if the Acrobat Reader utility is already present in your system, and otherwise prompts you on whether or not you want to install it. You must install the Acrobat Reader utility to be able to read the user's m
