Uniden TXC400 user manual

Summary of the content on the page No. 1

OWNER'S MANUAL
For use only with models: TRU446, TRU4465, TRU448, TRU4485, TRUC46 (Card Phone)
®
As an Energy Star Partner, Uniden has determined that
®
this product or product models meets the Energy Star
guidelines for energy efficiency.
®
Energy Star is a U.S. registered mark.
THE FCC WANTS YOU TO KNOW
Changes or modifications to this product not expressly approved by
Uniden, or operation of this product in any way other than as detailed
by the owner's manual, could void your authority to ope

Summary of the content on the page No. 2

UU808BH (TXC400) 5/7/02 5:55 PM Page 2 Welcome Congratulations on your purchase of the Uniden TXC400 optional handset and charger. This additional handset is for use with the Uniden TRU446, TRU448, TRU4465, TRU4485, or TRUC46 (Card Phone) base. You can place a fully featured cordless handset anywhere in your home where AC power is available to connect the handset charger. The original base will support up to 2 handsets (the original handset and one TXC400 handset). The TXC400 will not be an a

Summary of the content on the page No. 3

UU808BH (TXC400) 5/7/02 5:55 PM Page 3 Install the Battery Pack Charge the battery pack for at least 15-20 hours before completing the installation or using the handset. Press down on the battery cover 1 release and slide the cover down until it comes off. Connect the battery pack connector 2 observing the correct polarity (black and red wires) to the jack inside the battery compartment. Do not exert any force on this connection. It could cause damage to the battery or to the handset. The pla

Summary of the content on the page No. 4

UU808BH (TXC400) 5/7/02 5:55 PM Page 4 Low battery alert When the battery pack is very low and needs to be charged, the phone is programmed to eliminate functions in order to save power. If the phone is in the standby mode, ”Low Battery” appears on the LCD and none of the keys will operate. If the phone is in use, ”Low Battery” appears and the handset beeps. Complete your conversation as quickly as possible and return the handset to the base unit for charging. Cleaning the battery charging co

Summary of the content on the page No. 5

UU808BH (TXC400) 5/7/02 5:55 PM Page 5 Register the Handset You need to register the TXC400 before use. To register the additional handset, do the following steps in compliance with your original unit. For TRU446/TRU4465/TRU448/TRU4485 unit Place the TXC400 handset on the original unit’s base until you hear a confirmation tone. If the original base is mounted, you will need to hold the handset to the base until the status LED on the unit’s base is illuminated. • If the original base is a TRU4

Summary of the content on the page No. 6

UU808BH (TXC400) 5/7/02 5:55 PM Page 6 Call Transfer Feature You can transfer an outside call to the original unit. For more instructions, see the owner’s manual supplied with the original unit. To transfer a call to the Press xfer/del during a call. original unit When the original unit receives the transfered call, the TXC400 handset returns to the standby mode. To receive a transferred call Press talk/flash to answer the from the original unit transferred call. To cancel the transfer P

Summary of the content on the page No. 7

UU808BH (TXC400) 5/7/02 5:55 PM Page 7 One Year Limited Warranty Important: Evidence of original purchase is required for warranty service. WARRANTOR: UNIDEN AMERICA CORPORATION (“Uniden”) ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original retail owner, this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below. WARRANTY DURATION: This warranty to the original user shall terminate and be of no further effe