Summary of the content on the page No. 1
IMPORTANT MANUAL Do Not Throw Away
Poulan
OWNER'S MANUAL
WARNING:
MODEL:
Read this Owner's Manual and follow
all Warnings and Safety Instructions.
Failure to do so can result in serious
injury.
PRK17H42STB
LAWN TRACTOR
AL WAYS WEAR EYE PROTECTION DURING OPERA TION
178227 1.16.00 RE
Printed in U.S.A.
Summary of the content on the page No. 2
SAFETY RULES & Safe Operation Practices for Ride-On Mowers & IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. I. GENERAL OPERATION DO NOT: Read, understand, and follow all instructions in the Do not turn on slopes unless necessary, and then, turn manual and on the machine before starting. slowly and gradually downhill, if possible. Do notmow near drop-offs, d
Summary of the content on the page No. 3
SAFETY RULES & :Safe Operation Practices for Ride-On Mowers & Be sure the area is clear of other people before mowing. Look for this symbol to point out im- Stop machine if anyone enters the area. portant safety precautions. It means Nevercarry passengers or children even with the blades CAUTION!!! BECOMEALERT!!! YOUR off. SAFETY IS INVOLVED. Do not mow in reverse unless absolutely necessary. Always Iookdown and behind before and while backing. Nevercarry children. They may fall off and be serio
Summary of the content on the page No. 4
CONGRATULATIONS on your purchase of a new tractor. It PRODUCT SPECIFICATIONS has been designed, engineered and manufactured to give GASOLINECAPACITY 2.0 GALLONS you the best possible dependability and performance. AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily OILTYPE (API-SF-SJ): SAE 10W30 (above 32°F) remedy, please contact your nearest authorized service center. We have competent, well-trained technicians and SAE 5W-30 (below 32°F) the proper tools to service o
Summary of the content on the page No. 5
UNASSEMBLED PARTS Seat Steering Wheel Steering Wheel Insert (1) Washer @ 17/32 x 1-3/16 x 12 Gauge Steering Shaft (1) Knob Extension (1) Hex Bolt 3/8-16 x 1 Sleeve For Future Use Steering Adapter Slope Sheet (1) Large Flat Washer f__-. \ \ \ \ / \ \ (1) Lock washer 3/8 (2) Keys (1) Locknat 5/16-18 (2) Mulch (1) Hex Bolt 5/16-18 x 1-1/4 5
Summary of the content on the page No. 6
ASSEMBLY You rnew tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Standard INSERT wrench sizes are listed. (1) 9/16" wrenches Tire pressure gauge L-..---.--3/8 HEX BOLT (2) 1/2" wren
Summary of the content on the page No. 7
ASSEMBLY NOTE: You may now roll or drive your tractor off the skid. SEAT Follow the appropriate instruction below to remove the tractor from the skid. LABEL TO ROLL TRACTOR OFF SKID (See Operation section, page 10, for location and function of BOX controls) Press lift lever plunger and raise attachment lift lever to its highest position. Release parking brake by depressing clutch/brake pedal. Place freewheel control in freewheeling position to disengage transmission (See "TO TRANSPORT" in the Op
Summary of the content on the page No. 8
ASSEMBLY CHECK TIRE PRESSURE IMPORTANT: FOR SHIPPING PURPOSES, THE MULCHER PLATE WAS PREATTACHED TO YOUR The tires on your tractor were overinflated at the factory for MOWER, THE MULCHER PLATE MUST ONLY BE USED shipping purposes. Correct tire pressure is important for WITH THE MULCHING BLADES THAT CAME PACKED best cutting performance. SEPARATELY IN THE CARTON. Reduce tire pressure to PSI shown in "PRODUCT SPECIFICATIONS" section of this manual. YOUR MOWER CAME FACTORY EQUIPPED WITH HIGH PERFORMA
Summary of the content on the page No. 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. BATTERY CAUTION OR REVERSE FORWARD FAST SLOW WARNING A ENGINE ON ENGINE OFF OIL PRESSURE LIGHTS ON OVER TEMP 1_ LIGHT ! 0 m PARKING BRAKE UNLOCKED MOWER LIFT FUEL CHOKE MOWER HEIGHT LOCKED r 'l R N H L ATTACHMENT REVERSE NEUTRAL HIGH LOW PARKING BRAKE CLUTCH ENGAGED @@@@@ KEEP AREA CLEAR SLOPE HAZARDS ATTACHMENT (SEE SAFETY RULES SECTION) CLUTCH DISENGAGED IGNITION F
Summary of the content on the page No. 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations withyour tractor to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. ATTACHMENT LIGHT CLUTCH LEVER IGNITION SWITCH SWITCH POSITION AMMETER LIFT LEVER PLUNGER THROTTLE/CHOKE S ___ ATTACHMENT LIFT LEVER CLUTCH/ BRAKE PEDAL _ HEIGHT ADJUSTMENT KNOE PARKING BRAKE MOTION FREE WHEEL CONTROL CONTROL LEVER FIG. 5
Summary of the content on the page No. 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating SAFETY GLASSES your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over spectacles or standard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "OFF" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD). TO SET PARKING
Summary of the content on the page No. 12
OPERATION TO OPERATE ON HILLS TO ADJUST GAUGE WHEELS (See Fig. 7) Gauge wheels are properly adjusted when they are slightly offthe ground when mower is at the desired cutting height in with slopes greater than 15° and do not operating position. Gauge wheels then keep the deck in I A CAUTION: Donotdriveupordownhills drive across any slope. proper position to help prevent scalping in most terrain conditions. Choose the slowest speed before starting up or down Adjust gauge wheels with tractor on a
Summary of the content on the page No. 13
OPERATION BEFORE STARTING THE ENGINE Insert key into ignition and turn key clockwise to "START" position and release key as soon as engine CHECK ENGINE OIL LEVEL starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start The engine in your tractor has been shipped, from the after several attempts, move throttle control to fast factory, already filled with summer weight oil. position, wait a few minutes and try again. Ifengine still Check engine
Summary of the content on the page No. 14
OPERATION Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With f f motion control lever in neutral (N) position, slowly disengage clutch/brake pedal. Move motion control lever to full forward position and T hold for five (5) seconds. Move lever to full reverse J position and hold for five (5) seconds. Repeat this procedure three (3) times. I NOTE: During this procedure there will be no movement of drive wheels. The air is being remo
Summary of the content on the page No. 15
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE ._'o_ _/___,o_o_'_/_/" AS YOU COMPLETE ..... REGULAR SERVICE .%>"_4._:/'¢q'_..._/'_.-_e_"SERVICE DATES C_:: kkBiraek;,OsPe[_:i° n _ Check Operator Presence and T Interlock Systems I_ R Check for Loose Fasteners _1_ _7 A Sharpen/Replace Mower Blades 1_4 C Lubrication Chart 0 Check Battery Level R Clean Battery and Terminals I_ Check Transaxle Cooling Adjust Blade Belt(s) Tension _5 Adjust Motion Drive Belt(s) Tension Check Engine Oil Level _ Change E
Summary of the content on the page No. 16
CUSTOMER RESPONSIBILITIES TRACTOR MANDREL TRAILING ASSEMBLY EDGE UP Always observe safety rules when performing any mainte- BLADE nance. CENTER HOLE BRAKE OPERATION If tractor requires more than six (6)feet stopping distance at high speed in highest gear, then brake must be adjusted. (See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual). LOCK WASHER STAR TIRES Maintain proper air pressure in all tires (See "PRODUCT SPECIFICATIONS" section of this manual). FLAT WASHER Keep
Summary of the content on the page No. 17
CUSTOMER RESPONSIBILITIES NOTE: The original equipment battery on your tractor is Check the crankcase oil level before starting the engine and maintenance free. Do not attempt to open or remove caps or after each eight (8) hours of operation. Tighten oil fill cap/ covers. Adding or checking level of electrolyte is not dipstick securely each time you check the oil level. necessary. CLEAN AIR SCREEN TO CLEAN BATTERY AND TERMINALS Air screen must be kept free of dirt and chaff to prevent Corrosion
Summary of the content on the page No. 18
CUSTOMER RESPONSIBILITIES CLEAN AIR INTAKE/COOLING AREAS MUFFLER To insure proper cooling, make sure the grass screen, Inspect and replace corroded muffler and spark arrester (if cooling fins, and other external surfaces of the engine are equipped) as it could create a fire hazard and!or damage. kept clean at all times. SPARK PLUGS Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower housing and Replace spark plugs at the beginning of each mowing o
Summary of the content on the page No. 19
SERVICE AND ADJUSTMENTS CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Depress clutch/brake pedal fully and set parking brake. Place motion control lever in neutral (N) position. Place attachment clutch in "DISENGAGED" position. Turn ignition key '=OFF" and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. TRACTOR TO INSTALL MOWER (See Fig, 17) Raise attachmen
Summary of the content on the page No. 20
SERVICE AND ADJUSTMENTS BOTH FRONT LINKS MUST BE EQUAL IN LENGTH SIDE-TO-SIDE ADJUSTMENT (See Figs. 18 and 19) Raise mower to its highest position. At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance "A" on both sides of mower should be the same or within 1/4" of each other. If adjustment is necessary, make adjustment on one side of mower only. To raise one side of mower, tighten lift link adjustment nut on that side. _NUT "E" To lower one side of
