Azden Body-pack Transmitter 35BT user manual

Summary of the content on the page No. 1

Specifications
325UPR Receiver
Frequency Range UHF 188 Selectable Frequencies (566.125-589.875MHz)
Type of Reception Dual-channel Receiver
325 SYSTEM
Oscillator PLL Synthesized
RF Squelch Level -95dBm
User’s Guide
Frequency Response 50Hz – 15kHz
S/N Ratio >57dB (±5kHz) “A” Weighted
Audio Out MIC Level – unbalanced – 3.5mm Mini-Jack
-64 dBm – 600 ohms @ ± 5kHz deviation
-28 dBm – 600 ohms @ ± 40kHz deviation
325UPR • 35BT • 35HT • 35XT
Batteries 2 “AA” Alkaline (2 x 1.5V) -

Summary of the content on the page No. 2

(27) POWER: 20 Switches the transmitter “ON” or “OFF”. 4 (28) LCD Display: This display shows the following information: 6 3 TV:Transmit Channel Number: 30:01 – 33:47 Battery Condition: Using a 3 step indicator - 1 (Low) to 3 (High) 22 9 To change the TV:Transmit channel number: Use the tip of the tool provided and press the UP or DOWN button to the desired channel, number appears (refer to the included chart). Once the desired TV:Transmit channel number has been selected on the transmitter, set

Summary of the content on the page No. 3

Once the microphone is plugged into the 35XT the locking ring should be rotated Thank you for purchasing Azden’s 325 wireless microphone system. Depending on clockwise until snug. To remove the microphone, first rotate the locking ring which system you ordered this package will contain one or more of the following compo- counterclockwise and then, while pressing the XLR release, pull the microphone nents: the 325UPR receiver, the 35BT body-pack transmitter with EX-503L lavalier mi- crophone, t

Summary of the content on the page No. 4

Note: When using two transmitters with the 325UPR please do the following: (14) MIC Input Jack Plug the supplied EX-503L microphone into the MIC input jack and tighten the collar until A) Make sure that you use 2 different channel numbers that are at least 10 numbers snug (DO NOT OVERTIGHTEN). In addition to the EX-503L, other lapel and/or headset apart. This will prevent possible crosstalk between the 2 channels being used. For ex- microphones with 3.5mm mini plugs can also be used with th