Summary of the content on the page No. 1
Q-2411 PRO
Professional Preamp Mixer
User Guide
and Reference Manual
4295 Charter Street
Los Angeles Ca. 90058
www.AmericanAudio.us
12/06
Summary of the content on the page No. 2
Q-2411 PRO CONTENTS MAIN FEATURES....................................................................................................................................2 ELECTRICAL PRECAUTIONS...............................................................................................................4 SAFETY PRECAUTIONS.......................................................................................................................5 INTRODUCTION..................
Summary of the content on the page No. 3
Q-2411 PRO ELECTRICAL SAFETY PRECAUTIONS LINE VOLTAGE SELECTION WARNING: TO PREVENT FIRE OR ELECTRIC • The desired voltage may be set with the SHOCK HAZARD, DO NOT EXPOSE THIS VOLTAGE SELECTOR switch on the rear UNIT TO RAIN, LIQUIDS, OR MOISTURE panel (using a flat head screw driver). • Do not force the VOLTAGE SELECTOR switch as this may cause damage • If the VOLTAGE SELECTOR switch does CAUTION: TO PREVENT ELECTRIC SHOCK not move smoothly, please conta
Summary of the content on the page No. 4
Q-2411 PRO ELECTRICAL SAFETY PRECAUTIONS ELECTRICAL PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol, within an CAUTION: TO REDUCE THE RISK OF ELECTRIC The exclamation point within an equilateral triangle is equilateral triangle, is intended to alert the user to the SHOCK, DO NOT REMOVE THE COVER (OR BACK). intended to alert the user to the presence of important presence of uninsulated "dangerous voltage" within the THERE A
Summary of the content on the page No. 5
Q-2411 PRO SAFETY PRECAUTIONS 8. Never plug this mixer in to a dimmer pack. 1. For adult use only - Keep out of the reach of children. 9. Do not let insecticides, benzene, or thinner come in contact with the surface of the 2. Water and Moisture - The player should not unit. be used near water - for example, near a bath tub, kitchen sink, laundry tub, in a wet base- 10. This unit is intended for indoor use only, use ment or near a swimming pool, etc. Do not of th
Summary of the content on the page No. 6
Q-2411 PRO INTRODUCTION Introductions: Congratulations and thank you for purchasing the American Audio® Q-2411 PRO mixer. This mixer is a representation of American Audio’s continuing commitment to produce the best and highest quality audio products possible at an affordable price. Please read and understand this manual completely before attempting to operate your new mixer. Please carefully read and understand the instructions in this manual thorough
Summary of the content on the page No. 7
Q-2411 PRO UNPACKING Every Q-2411 PRO has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your mixer for any damage and be sure all equipment neces- sary to operate the mixer has arrived intact. In the event damage has been found or parts are missing, please contact our toll free c
Summary of the content on the page No. 8
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS 1 2 3 4 5 6 7 20 19 18 17 16 15 14 13 12 11 10 9 8 1. MICROPHONE 1 - This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male plug. The volume output level for this microphone will be controlled by its own respective CHANNEL KNOB (20). Note: We recommend that you use a 500-600ohm microphone for the best sound quality. 2. CHANNEL GAIN CONTROL - This adjustment is used to adjust the audio source signa
Summary of the content on the page No. 9
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS CONT. each channel. Each channel may only be assigned one input source at a time. This switch must be in the “phono” position for turntable operation. 5. MASTER OUTPUT BALANCE CONTROL - This knob is used to control the pan, adjust how much of the signal is sent to the left and right output level. For true stereo imaging, maintain the knob in the 12 o’ clock position. 6. POWER SWITCH - This is the main power ON/OFF button. A r
Summary of the content on the page No. 10
Q-2411 PRO FRONT PANEL - CONTROLS AND FUNCTIONS CONT. For example; Assuming you have two compatible American Audio™ CD players or a compatible dual CD player connected to channels one and two. When the Fader "Q" Start option is turned on, sliding the crossfader to the far left position will trigger playback on CD player 1. When the crossfader is pushed to the far right position, playback on CD player 2 will begin, and CD player 1 will return to the cue position. Refe
Summary of the content on the page No. 11
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS 21 22 34 33 32 31 30 29 28 27 24 26 24 25 24 23 21. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the two available ground terminals. This will reduce the humming and popping noises associated with magnetic phono cartridges. 22. MIC ATTENUATOR - This knob is used to adjust the MIC 1 and MIC 2 input level. 23. MICROPHONE 2 CONNECTOR - This jack is used to a connect a micro
Summary of the content on the page No. 12
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS CONT. decks, etc.) to these jacks when the LINE LEVEL SELECTOR SWITCH (24) is in the “PHONO 2” posi- tion, THIS MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel input and the white represents the left channel input. Input volume will be controlled by the channel two fader. The channel SOURCE SELECTOR SWITCH (4) must be in the "Phono 2/Aux 2" position, to monitor any source connected to these
Summary of the content on the page No. 13
Q-2411 PRO REAR PANEL - CONTROLS AND FUNCTIONS CONT. 31. PLAYER CONTROL - PLAYER 1 CONTROL - This jack is used to control the “Q-Start” function between the mixer and a compatible American Audio® or American DJ® CD Player. Using the mini plug included with your CD player, connect from the CD player controller out jack to this jack. Player A “Q-Start” functionallity will be controlled by the left side of the CROSSFADER (16). For more information on “Q-Start” functionallity
Summary of the content on the page No. 14
Q-2411 PRO TYPICAL MIXER SET-UP CASSETTE DECK T U R N T A B L E This image details a typical DJ Set Up consisting of a microphone, turn- tables, CD players, and a tape deck. Note: Turntables can only be connected to the PHONO LEVEL RCA JACKS. Be sure the LINE LEVEL SELECTOR SWITCHES are in the T U R N T A B L E "PHONO" position when using turntables. ©American Audio® - www.americanaudio.us - Q-2411 PRO Instruction Manual Page 14
Summary of the content on the page No. 15
Q-2411 PRO TYPICAL MIXER SET-UP RCA to RCA Patch Cables Balanced XLR male to XLR female Cables CASSETTE DECK American Audio V4001™ Speaker Cables Typical Balanced Output Set-up This image details a typical stereo output layout. Note the use of the Balanced XLR Jacks on both the mixer and the amplifier. Always use the balanced output jacks whenever possible. The balanced output jacks should always be used for cable runs in excess of 15 feet. Using the balanced jacks will
Summary of the content on the page No. 16
Q-2411 PRO CLEANING Due to fog residue, smoke, and dust, cleaning the mixer should be carried out periodically to residue build up. 1. Use normal glass cleaner and a soft cloth to wipe down the outside casing. 2. Use a cleaner specially designed for electronics to spray in and around the knobs and switch. This will reduce small particle built up that can effect the proper operation of the mixer. 3. Cleaning should be carried out every 30-60 days
Summary of the content on the page No. 17
Q-2411 PRO TROUBLESHOOTING Trouble Shooting: Listed below are common problems you may encounter, and solutions. There is no power to the unit: 1. Be sure you have connected the power cord to a correct wall outlet. There is little or no sound: 1. Check the input selector switch. Make sure it is set to the device that is currently playing. 2. Check to see if the connection cables are connected properly. The sound is distorted: 1. Make sure that the Gain level control is no
Summary of the content on the page No. 18
Q-2411 PRO WARRANTY The Q-2411 PRO carries a one year limited warranty. We recommend you fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a R.A. (return authorization) number. If the mixer is under warranty, you must provide a proof of purchase invoice. You may obtain a R.A. number by contacting our customer support team on our toll free number
Summary of the content on the page No. 19
Q-2411 PRO SPECIFICATIONS Model: Q-2411 4 Channel Mixer POWER SUPPLY: AC 115v~60Hz/230v~50Hz, User Selectable Single Voltage: AC 100V, 50/60Hz (Japan) AC 110V, 60Hz (Colombia) AC 120V, 60Hz (U.S.A. and Canada) AC 127V, 60Hz (Mexico) AC 220V, 50Hz (Chile and Argentina) AC 220V, 60Hz (Philippines and Korea) AC 230V, 50Hz (Europe, U.K., New Zealand, South Africa, and Singapore) AC 240V, 50Hz (Australia) DIMENSIONS:
Summary of the content on the page No. 20
©American Audio® World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA Tel: 323-582-3322 Fax: 323-582-2941 Web: www.americanaudio.us E-mail: info@americandj.com
