Summary of the content on the page No. 1
SIP IP Phone
VIP-155PT User’s manual
Summary of the content on the page No. 2
Copyright Copyright (C) 2006 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and documentation are copyrighted. No part of this User’s Manual may be copied, photocopied, reproduced, translated, or reduced to any electronic medium or machine-readable for
Summary of the content on the page No. 3
Revision User’s Manual for PLANET SIP IP Phone: Model: VIP-155PT Rev: 1.0 (October, 2006) Part No. EM-VIP155PTV1 3
Summary of the content on the page No. 4
TABLE OF CONTENTS Chapter 1 ................................................................................................ 6 Introduction............................................................................................ 6 Overview............................................................................................................................6 Package Content ..............................................................................................................
Summary of the content on the page No. 5
Syslog Config ...........................................................................................................36 Time Set....................................................................................................................36 Reboot.......................................................................................................................37 Chapter 4 Keypad Configurations...................................................... 38 Keypad Function ............
Summary of the content on the page No. 6
1 Chapter 1 Introduction Overview Meeting the next-generation Internet telephony service demands, PLANET Technology provides feature-rich, toll-quality Internet telephony service solutions. The 802.3af Power over Ethernet (PoE) IP Phone VIP-155PT brings cost-effective solution for voice communications and interoperates VoIP hardware and systems from major third party vendors with traditions of PLANET VoIP family. As a feature-rich IP Phone, the VIP-155PT fulfills your needs.
Summary of the content on the page No. 7
Configuration of the VIP-155PT can be performed in minutes via the keypad, or web interfaces. Using the built-in LCD display, the VIP-155PT offers user-friendly configuration guidelines, machine operation status, call status displays, and incoming call identification. • Feature-rich keypad IP Phone The VIP-155PT integrates a high-quality speakerphone with the Call Hold, Forward and Transfer functions and also provides advanced telephone features, such as 9 speed-dial keys, last number red
Summary of the content on the page No. 8
Physical Details The following figure illustrates the front/rear panel of VIP-155PT. Front View and Keypad function Front Panel of VIP-155PT Keypad Description 1 LCD Display Menu and all status shall be displayed for users. Speed Dial To make a speed dial call by pressing the speed dial key No.1 2 ~ No.9. No.1~No.9 Circularly show phone number, wan ip, registration status, 3 Sysinfo server ip address, gateway and mask info. 4 Out call Show the outgoing calls history. To
Summary of the content on the page No. 9
Press to dial the last dialed number when the IP Phone is 7 Redial off-hooked. 8 PWR The green light goes on when power on. The green light goes on-off when there is an incoming call. 9 Message The light goes constant on when there have voice message (Proxy Mode.) To switch between the usage of the handset and the speaker 10 Handfree devices. To increase the volume of voice when at off-hooked state. 11 Vol+ To page up menu when at configuration mode. 12 Mute Press to mute sounds wh
Summary of the content on the page No. 10
Rear View 3 2 1 Rear Panel of VIP-155PT RJ-45 connector, to maintain the existing network structure, 1 LAN connected directly to the PC through straight CAT-5 cable RJ-45 connector, for Internet access, connected directly to Switch/Hub through straight CAT-5 cable. 2 WAN (PoE) Please connect the WAN interface when using IEEE802.3af PoE power supply (PT model only) 3 12V DC 12V DC Power input outlet The Power over Ethernet support on PLANET VIP-155PT comp
Summary of the content on the page No. 11
2 Chapter 2 Preparations & Installation Physical Installation Requirement This chapter illustrates basic installation of VIP-155PT • Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors. • TCP/IP protocol must be installed on all PCs. For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable modem (for WAN port usage) Administration Interface PLANET VIP-155PT provides GUI (Web based, Graphical User Interface) for mach
Summary of the content on the page No. 12
Please locate your PC in the same network segment (192.168.0.x) of VIP-155PT. If you’re not familiar with TCP/IP, please refer to related chapter on user’s manual Note CD or consult your network administrator for proper network configurations. LAN/WAN Interface quick configurations Nature of PLANET VIP-155PT is an IP Sharing (NAT) device, it comes with two default IP addresses, and default LAN side IP address is “192.168.0.1”, default WAN side IP address is “172.16.
Summary of the content on the page No. 13
Parameter Description Enable this option to switch to bridge mode. VIP-155PT Bridge Mode won’t assign IP for its LAN port in bridge mode and its LAN and WAN port will be in the same network. LAN IP address of VIP-155PT IP address Default: 192.168.0.1 LAN IP address of VIP-155PT Subnet Mask Default: 255.255.255.0 DHCP Service Enable DHCP service in LAN port Enable NAT function. If Bridge mode is enable, this NAT function will be disabled. It is suggested to keep the DHC
Summary of the content on the page No. 14
Connection Type Data required. Static IP The ISP will assign IP Address, and related information. Get WAN IP Address automatically; it is no need to DHCP configure the DHCP settings. The ISP will assign PPPoE username / password for PPPoE Internet access, Please consult your ISP personnel to obtain proper PPPoE/IP address related information, and input carefully. If Internet connection cannot be established, please check Hint the physical connection or contact the I
Summary of the content on the page No. 15
3 Chapter 3 Web Configurations Configuring and monitoring your VIP-155PT from web browser The VIP-155PT integrates a web-based graphical user interface that can cover most configurations and machine status monitoring. Via standard, web browser, you can configure and check machine status from anywhere around the world. Overview on the web interface of VIP-155PT With web graphical user interface, you may have: More comprehensive setting feels than traditional command line in
Summary of the content on the page No. 16
VIP-155PT main page Current State Current state information Shows the WAN and LAN port connecting state and Network current settings Part show the working state of VoIP, you can see whether VOIP IP Phone has registered the public sip server Phone Number Shows the public sip and private sip phone numbers 16
Summary of the content on the page No. 17
WAN Config: Three methods are available for Internet Access Static IP If you are a leased line user with a fixed IP address, fill out Fixed IP User the following items with the information provided by your ISP. IP Address check with your ISP provider Netmask check with your ISP provider Default Gateway check with your ISP provider DHCP IP If there is DHCP server in your local network, VIP-155PT will automatically obtain WAN port network information Dynmaic IP User from your D
Summary of the content on the page No. 18
LAN Config Field Description Enable this option to switch to bridge mode. IP phone won’t assign IP for its LAN port in bridge mode and its LAN and WAN port will be in the same network Bridge Mode (This setting won’t take effect unless you save the config and reboot the device) LAN IP address of VIP-155PT IP address Default: 192.168.0.1 LAN IP address of VIP-155PT Subnet Mask Default: 255.255.255.0 DHCP Service Enable DHCP service in LAN port NAT Enable NAT SIP Config
Summary of the content on the page No. 19
Setting page of public SIP server. Field Description Register Server Addr Register address of public SIP server Register Server Port Register port of public SIP server Username of your SIP account (Always the same as the phone Register Username number) Register Password Password of your SIP account IP address of proxy SIP server (SIP provider always use the Proxy Server Addr same IP for register server and proxy server, in this case you don’t need to configure the proxy server inf
Summary of the content on the page No. 20
DTMF signal sending mode: support RFC2833, DTMF_RELAY DTMF Mode (inband audio) and SIP info Server Type It could support different SIP Proxy providers Current IP PHONE SIP version. Set to RFC 2543 if the gate need RFC Protocol Edition to communicate to devices (such as CISCO5300) using the SIP 1.0. Default is RFC 3261 Co-work with Server Auto Swap and Detect Interval Time. Enable this option, IP PHONE will periodically detect whether the public SIP server is available, if the server is
