Dakota Digital LED Tail Lights LAT-NR340 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
LAT-NR340
LED Tail Lights for ’73-’87 Chevy Fleetside Pickup
and ’87-’91 Suburban/Blazer

MAN#650203

Kit Includes:

Installation:

1. Remove the tail light lenses. There are four screws holding each lens in place.
2. Remove the light bulbs.

3. Now is a good time to clean the lenses and housings. If lenses are in bad shape a new set is
recommended.
4. DO NOT remove the tape from the LED assemblies yet!

MAN#650203

Summary of the content on the page No. 2

5. Test fit the assembly into the tail light housing as shown below to make sure it aligns correctly. 6. Before mounting the new LED assembly into the housing, plug the bulb base into the stock bulb socket and test the tail lights and flashers to make sure everything is working correctly. 7. Make sure the tail light housings are clean and dry so the single use primer applicator can be used for both housings. Apply the primer to the outside edge of the housing where the tape wi

Summary of the content on the page No. 3

9. Make sure the bulb base is fastened securely in the stock bulb socket. Carefully place the LED assembly onto the housing and press down firmly. 10. Fasten the lens back on with the four original screws. 11. Repeat steps above for the other side. 12. Test the tail lights, brake lights, and turn signals. If the turn signals do not flash you will need to upgrade your flasher. If you are replacing only the rear turn signals you should be able to use a heavy duty electronic flasher f