Dakota Digital LED Tail Lights LAT-NR350 user manual

Summary of the content on the page No. 1

INSTALLATION INSTRUCTIONS
LAT-NR350
LED Tail Lights for 1964-1966 Mustang

MAN#650204

Kit Includes:

Installation:

1. Remove both right and left tail light lenses as described below at the same time, taking care to
keep the left and right lenses and trim with the correct side of the vehicle.
2. Remove the four screws that hold the chrome tail light trim piece.
3. Remove the tail light trim piece and the lens.
4. Remove the light bulb from socket.

5. Loosen the lens seal

Summary of the content on the page No. 2

8. DO NOT remove the backing from the tape yet! Place the LED assembly in the housing. The wide black bar on the wire side of the LED assembly is marked to show which end of the assembly should be up. Note the places where the tape touches the housing. 9. Squeeze the primer tube to break the glass bulb and wet the brush end with primer. Rub the primer on the lenses and the housings at the places where the tape will touch. Treat both left and right housings and lenses at the same time

Summary of the content on the page No. 3

15. Test the tail lights, brake lights, and turn signals. If the turn signals do not flash you will need to upgrade your flasher. If you are replacing only the rear turn signals you should be able to use a heavy duty electronic flasher from your local parts store. If you are replacing both front and rear or do not have front bulbs you will need a no-load flasher, Dakota Digital part number LAT-NLF. SERVICE AND REPAIR DAKOTA DIGITAL offers complete service and repair of its product