Summary of the content on the page No. 1
ULIN_016357_30090.fm Page 1 Wednesday, February 7, 2007 12:40 PM
Use and Care Guide
Refrigerator Models:
2115R, 2175R
2115R 2175R
Summary of the content on the page No. 2
1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. U-Line products are making life mor
Summary of the content on the page No. 3
2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ...............................................................................
Summary of the content on the page No. 4
This page intentionally left blank 4 2115R, 2175R
Summary of the content on the page No. 5
WARNING 3 Safety Precautions SHOCK HAZARD - Electrical Grounding Required. IMPOR IMPORT TAN ANT T � Never attempt to repair or perform maintenance on the unit until the electricity PLEASE READ all instructions completely before has been disconnected. attempting to install, operate, or service your unit. � Never remove the round grounding prong from • Proper installation procedures must be followed the plug and never use a two-prong grounding if this unit is being initially installed, or is
Summary of the content on the page No. 6
� Two contoured, self-contained, inner door “pick-off” 4 Product Features shelves are adjustable for storage of a variety of different bottle, can, and container sizes and shapes. Échelon Refrigerator � The lower inner door shelf accommodates a two liter or 750 mL bottle. Models 2115R, 2175R � Self-closing door hinges engage when the door is open Exclusive Features of Échelon approximately 8-10 in. (20-25 cm), ensuring a positive door seal and preventing door bounce back. � Model 2115R is
Summary of the content on the page No. 7
Temperature Control 5 Operation Checking Product Temperature ULIN_0080_A Figure 2 IMPOR IMPORT TAN ANT T Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected. ULIN_0093_A Initial Startup Figure 4 All U-Line units are shipped with controls that are preset. No initial adjustments are required. To check the actual product temperature, in re
Summary of the content on the page No. 8
Temperature Display Interior Lighting To display the interior temperature: The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional lighting function. The blackout/ 1. Touch and hold the WARMER icon (Figure 5, 2) for Sabbath mode (not Star K certified) will turn the interior approximately five seconds and release when the °F light and display (Figure 3, 3) off for a preset 36-hour symbol in the display (Figure 5, 3) begins to flash. period. 2. The display (Figure 5
Summary of the content on the page No. 9
Normal Operating Sounds Outdoor, Marine and RV Usage All models incorporate rigid foam insulated cabinets to Some U-Line models are designed to operate in outdoor, provide high thermal efficiency and maximum sound marine and RV environments. For best performance, keep reduction for its internal working components. In spite of the unit out of direct sunlight. this technology, your model may make sounds that are � If the unit will be shut off for five days or more, prop unfamiliar. door open
Summary of the content on the page No. 10
Maintenance 6 Cleaning and Maintenance Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The General Cleaning maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you Exterior Cleaning (As Required) have pets or other special considerations. Black and White Models: Defrosting � Surfaces may be cleaned with a mild detergent and warm water solution. Do not use solvent-based or Frost-Free Models ab
Summary of the content on the page No. 11
To defrost: CAUTION 1. Turn unit off. DO NOT use any type of cleaner on the condenser 2. Remove all products from the interior and prop the unit. door in an open position (2 in. (5 cm) minimum). 4. Clean the condenser coil (Figure 9, 2) using a soft 3. Allow the frost to completely melt naturally. Clean the brush with a “combing” action or vacuum cleaner. Do interior and all removed components using a mild non- not touch the condenser coil. abrasive detergent and warm water solution applied
Summary of the content on the page No. 12
Door Alignment Check and Adjustment IMPOR IMPORT TAN ANT T When properly aligned: 1 � The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. � The door gasket will be firmly in contact with the 23 ULIN_0201_A perimeter of the cabinet and not pinched on the hinge side of the door. Figure 14 The following procedure will correct for up to 1/4 in. 3. Turn the door upside down and inspect the hinge plate misalignment: m
Summary of the content on the page No. 13
Door Reversal 1 ULIN_0002_A Figure 18 2. Remove plastic screw plugs (three each, top and bottom) (Figure 18, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (Figure 17, 2) and reinstall hinge screw pin (Figure 17, 1). ULIN_0015_A Figure 16 Black and white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used o
Summary of the content on the page No. 14
5. Remove the two door closer inserts (Figure 20, 1) from Door Shelf Removal/Insertion the existing bottom hinge and install as shown on the new bottom hinge (Figure 19, 1). 6. Remove existing bottom hinge (three screws) and 1 remount on opposite side TOP. Remove hinge screw pin. 7. Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side. 2 ULIN_0006_A ULIN_0039_A Figure 21
Summary of the content on the page No. 15
Glass Shelf Removal/Installation Light Bulb Replacement Remove the shelves as follows: To replace the light bulb in your U-Line unit: 2 1 3 1 ULIN_0001_A 2 Figure 24 1. Grasp the edges of the light housing lens (Figure 24, 1) opposite the exposed tab and gently push the lens toward the tab (Figure 24, 2). ULIN_0066_A 2. Pull the edge of the lens down (Figure 24, 1) and Figure 23 swing it out of the light housing. 1. Pull shelf out about 6" (Figure 23, 1) until back of IMPOR IMPORT TAN ANT T
Summary of the content on the page No. 16
7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information on possible causes and remedies. Most often, this will resolve the problem without the need to call for service. If Service is Required
Summary of the content on the page No. 17
Troubleshooting Guide NOTE: Recommended temperature setting is 38°F. DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate and No electrical supply Plug unit in or check circuit breaker. electronic display is blank. No interior light Loose or burned out bulb Tighten or replace bulb (See MAINTENANCE; LIGH
Summary of the content on the page No. 18
Electronic Control Quick Guide All Models Task Touch Touch Display Comment Turn ON/OFF Hold 10 seconds Release when °F flashes. or °F flashes after first touch, or or Adjust set-point saved after 5 Temperature seconds of inactivity and °F Touch to change temperature Touch and release stops flashing.* View Actual For Wine Coolers, see Use Hold 5 seconds Release when °F flashes. Temperature and Care Manual. Change °F-°C Hold or Repeat to switch back. Blackout Display (and cabinet light)
Summary of the content on the page No. 19
U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During the initial one
Summary of the content on the page No. 20
ULIN_016357_30090.fm Page 20 Wednesday, February 7, 2007 12:40 PM For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.com For more than four decades, U-Line has distinguished itself as the leader in built-in under-counter ice making, refr
