Summary of the content on the page No. 1
®
USE AND CARE GUIDE
1000 & ADA SERIES
WINE CAPTAIN® MODELS
BEVERAGE CENTERS
REFRIGERATORS
1175WC
1115WC 1175BEV
1175R 1115R ADA24RGLS
U-LINE.COM
The Built-In Undercounter Leader Since 1962
Summary of the content on the page No. 2
Introduction Please Record Your Model Information You will need your product model and serial number when you request additional information or services. You can find this information on the serial plate located on the upper right or back Congratulations on your purchase of a U-Line refrigeration wall in the interior of your product. This information also appears product. on the warranty registration card. Building on 45 years, U-Line has captivated those with an appreciation for the finer
Summary of the content on the page No. 3
1 Table of Contents U-Line1000 Series i - Introduction .................................................................................................................................................................i Read and save this Use and Care Guide. .........................................................................................................i Please Record Your Model Information ...................................................................................................
Summary of the content on the page No. 4
2 U-Line Use and Care Guide
Summary of the content on the page No. 5
2 Safety Precautions General Precautions Use this appliance for its intended purpose only and follow these IMPO IMPOR RT TANT ANT general precautions with those listed throughout this guide: • PLEASE READ all instructions before installing, operating, or servicing the appliance. DANGER RISK OF CHILD ENTRAPMENT. Before you throw away your • Proper installation procedures must be followed when old refrigerator or freezer, take off the doors and leave shelves completing an installation or relo
Summary of the content on the page No. 6
Wine Captain® Model Features: 3 1000 Series Product Features Capacity.15” Wine Captain Model up to 24 Bottles. 24" Wine Captain Model up to 48 Bottles. Multiple temperature zones. Maintains wine at their proper serving temperature. Top Approximately 55°F (Red). Middle Approximately 50°F (White). Bottom Approximately 45°F All 1000 & ADA Series Model Feature: (Sparkling). Safely stores three or two types, or a single type, of wine. Touch Pad Digital Controls. Provides ability to set and see t
Summary of the content on the page No. 7
4 Product Operation Adjusting AirTemperature Air Flow IMPO IMPOR RT TANT ANT Adjust the set point temperature in single increments, IMPO IMPOR RT TANT ANT and wait 24 hours for the temperature to stabilize before The unit requires proper air flow to perform at its highest rechecking. efficiency. Do not block the front grille or internal fans at any time, or the unit will not perform as expected. Do not 4 3 2 install the unit behind a door. 5 1 To adjust the set point temperature: 1. Press a
Summary of the content on the page No. 8
Interior Lighting Checking Product Temperature Normal Operation. Opening the door will cause the interior of the cabinet to illuminate. Use the LIGHT button (1) on the control panel to change the lighting functions. 4 3 2 5 1 Timed Lighting. For Wine Captain Models and Beverage Centers the interior of the cabinet is illuminated for a timed four- hour period. To check the actual product temperature in the unit. 1. Press and release the LIGHT button (1) (the °F symbol will 1. Partially fill a
Summary of the content on the page No. 9
Electronic Control Quick Guide Task Touch Touch Display Comment Turn ON/OFF Hold 10 seconds Release when °F flashes. or °F flashes after first touch, or or Adjust set-point saved after 5 Temperature seconds of inactivity and °F Touch and release Touch to change temperature stops flashing. View Actual WC models will scroll top/ Hold 5 seconds Release when °F flashes. Temp mid/bottom temps. Change F/C Hold or Blackout will end in 36 Display (and cabinet light) will not Blackout Mode H
Summary of the content on the page No. 10
5 U-Line Wine Guide Matching Food and Wine Although there are no hard fast rules for matching wine to food, Looking Behind the Label observe some guidelines. Delicate dishes should be accompanied To most, wine is a delicious mystery. We purchase it, uncork it, by lighter more delicate wines. Full-flavored foods should be and savor its taste and beauty. But there is so much more to true matched with fuller-bodied wines. wine appreciation. Many secrets are simply too good to keep As a genera
Summary of the content on the page No. 11
The Cork: A Mystery on Its Own. Ideal Wine Storage Considerations Cork Presentation. The ritual of the presentation of the cork Temperature: The most important element about storage has a rich and fascinating history dating back to the late 1800's. A temperature is stability. If wine is kept in a stable environment phylloxera (root louse) devastation to the vineyards severely between 40°F and 65°F, it will remain sound. A small 1-2 degree limited the supply of great wines. Restaurateurs w
Summary of the content on the page No. 12
Wine Stocking Recommendation Wine Rack Removal and Installation Specially designed horizontal wine racks properly positioned the To remove a rack from the cabinet: bottles so the wine remains in contact with the cork and assure 1. Remove any bottles stored on the rack. the cork does not become dry. 2. Grasp the end of the rack, and gently slide it out until it stops. Stock the unit as follows: 1. Stock the wine racks beginning with the lowest rack, at the back, and working forward. Stagger th
Summary of the content on the page No. 13
Wood Trim Finishing Staining and final finish application: WARNING IMPO IMPOR RT TANT ANT You MUST remove the wood trim from the unit for DO NOT use oil-based stains on wood trim. Vapors from staining or finishing to prevent permanent damage to the inner liner of the unit. Allow stain or finish to dry oil-based stains will permanently penetrate the liner and will not dissipate over time. thoroughly (at least 24 hours for each coat) following the product manufacturer’s instructions before 1
Summary of the content on the page No. 14
6 Maintenance Lightbulb Replacement Removing and Installing Grille To replace the lightbulb in your U-Line unit: WARNING 1. Find the light located at the top of the unit. Grasp the edges of Disconnect electric power to the unit before removing the light housing lens (1) opposite the exposed tab and gently the grille. push the lens toward the tab (2). 2. Pull the edge of the lens down (1) and swing it out of the light WARNING housing. DO NOT touch the condenser fins(4). The condenser fins ar
Summary of the content on the page No. 15
Removing and Installing Interior Shelves 3 1 2 For models equipped with glass shelves having shelf supports, remove the shelves as follows: For models equipped with glass shelves having recessed shelf supports, remove the shelves as follows: 1. Open door completely. 2. Grasp the shelf edge in the center and slide the shelf from the 1. Pull shelf out about 6" (1), until back of shelf clears the “hump” unit. on the right-hand side. 2. Tilt up right-hand edge of shelf (2). Insert the shelves as
Summary of the content on the page No. 16
Wire Shelf Removal/Installation For ADA models equipped with wire racks, reposition the shelves as follows: Figure 1 1. Remove shelf retention clip. 2. Pull shelf out about 6" (1), until back of shelf clears the “hump” on the right-hand side. 3. Tilt up right-hand edge of shelf (2). 4. Remove shelf from unit by pulling out (3). Insert the shelves as follows: 1. To move to a different position in the unit, insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit wh
Summary of the content on the page No. 17
To reverse the door: 7 Standard Doors Remove grille: Remove the grille see MAINTENANCE section of this guide. Door Alignment and Adjustment Align and adjust the door if it is not level, or is not sealing properly. If the door is not sealed the unit may not cool properly, or excessive frost may form in the interior. IMPO IMPOR RT TANT ANT Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket
Summary of the content on the page No. 18
1 Install bottom hinge: Prepare door for reinstallation: 1. If you have a plate hinge, reorient the pivot screw so it protrudes the opposite direction form the hinge. Remove the For black or white doors: pivot screw from the hinge. Turn the plate over and reinstall 1. Remove plastic hole plug from top of door handle and reinstall the screw. on opposite side. 2. Align hinge outer edge with cabinet. For models with a plate 2. Remove plastic hinge bushing on bottom of door and reinstall on hi
Summary of the content on the page No. 19
. 8 Cleaning Defrosting Exterior Cleaning Automatic Defrost Models Vinyl Clad (Black or White) Models: Frost on the rear wall is normal and will melt during each off cycle. If there is excessive build-up of 1/4” or more, manually defrost the • Clean surfaces with a mild detergent and warm water solution. unit. Do not use solvent-based or abrasive cleaners. Use a soft sponge and rinse with clean water. Wipe with a soft, clean • Ensure the door is closing and sealing properly. towel to preve
Summary of the content on the page No. 20
Condensor Cleaning Storage, Vacation and Moving Interval - Every Six Months If not using the unit for an extended period, or otherwise stored, follow these steps completely: To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending WARNING on environmental conditions, more or less frequent cleaning may be necessary. Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Fa
