Life Fitness Exercise Bike Lifecycle 9100 user manual

Summary of the content on the page No. 1

LIFE FITNESS EXERCISE BIKE
INSTALLATION INSTRUCTIONS

Summary of the content on the page No. 2

Congratulations... and welcome to the world of and the Lifecycle 9100 exercise bike. The following Parts Identification Listing and the step by step installation procedures have been assembled to make the set-up of your exercise bike as quick and easy as possible. Please take special note of the following important points prior to choosing a location and beginning assembly of the Lifecycle exercise bike…

Summary of the content on the page No. 3

S A F E T Y F I R S T ! ⇒ DO NOT locate the Lifecycle 9100 exercise bike outdoors, near swimming pools, or in areas of high humidity. ⇒ DO NOT operate your Lifecycle 9100 exercise bike if it has been dropped, damaged, or even partially immersed in water. Contact Life Fitness Customer Support Services at the number on the back page of this Installation Instruction Guide. ⇒ DO NOT locate the Lifecycle 9100 exercise bike any closer than 30 inches ( 76 cm ) to a television set.

Summary of the content on the page No. 4

TOOLS REQUIRED FOR ASSEMBLY... Phillips screwdriver, 1/2” wrench PARTS DESCRIPTION STABILIZER/HANDLEBAR BOLT Qty:3 CONSOLE SCREW Qty: 4 1 2 0017-00101-0933 0017-00101-1104 SEAT ASSEMBLY Qty: 1 COLLAR Qty: 1 3 4 AK18-00127-0000 0K18-01156-0002 HANDLEBAR ASSEMBLY Qty: 1 DISPLAY CONSOLE ASSEMBLY Qty: 1 5 6 AK49-00015-0000 AK49-0008-0001 STABILIZER BAR Qty: 1 9V ALKALINE BATTERY Qty: 1 7 8 AK18-0070-0000 0017-00003-

Summary of the content on the page No. 5

Summary of the content on the page No. 6

Step 1 Before proceeding, familiarize yourself with the parts of the Lifecycle 9100 exercise bike and make sure that you have received all the items described in the Parts List. Step 2 Remove the STABILIZER BAR (#7) from the carton base. Use the empty CONSOLE CARTON to raise the rear of the LIFECYCLE exercise bike as shown. Remove the two BOLTS (#1) from the bottom of the SHIPPING STABILIZER, save the BOLTS and store the SHIPPING STABILIZER with the other shipping containers.

Summary of the content on the page No. 7

Step 7 Slide the COLLAR (#4) down until it completely covers the HANDLEBAR ASSEMBLY HARDWARE and the HANDLEBAR POST. Secure the COLLAR by squeezing the sides and pushing downward firmly. Step 8 There is a large hole in the rear of the DISPLAY CONSOLE (#6) through which you can see a 16-PIN CONNECTOR and a 3-PIN CONNECTOR. These correspond to the matching CONNECTORS on the WIRE HARNESS protruding from the top of the HANDLEBAR. Properly align the locking tabs of the 16-PIN CONNECTOR

Summary of the content on the page No. 8

OPERATION CHECKLIST ⇒ Insure that the STABILIZER BAR and HANDLEBAR BOLTS are tight. ⇒ Make sure the exercise bike is properly leveled and stable. ⇒ Read the entire Operation Manual before using the exercise bike. ENGLISH/METRIC DEFAULT SETTING TOGGLE The default setting of the Lifecycle 9100 exercise bike display console is set to English units of measurements at the factory. If your display console will require units of measurements to be in metric, it may be necessary to chan