Manual do usuário Stanton RM-80

Resumo do conteúdo contido na página número 1

FADER CLE A N I N G
The RM-80 faders may need lubrication from time to time. This will extend the
fader life and eliminate any potential damage due to extended heavy usage.
RM-80 Professional performance mixer
Cleaning Instructions
1. Remove the fader and disconnect the cable coming from the mixer. To remove
the crossfader, unsecrew the outer screws (removing the 2 inner screws will
detach the fader from the fader plate). To remove the line faders, remove all 4
screws.
2. Spray a small amount of

Resumo do conteúdo contido na página número 2

T RO U B LE S H O OT I N G Thank you for making Stanton your first choice in professional DJ mixers. Problem Cause Solution This new, innovative family of mixers has been developed with input from the profes- Excessive hum when using Poor ground connection. Properly connect turntable sional DJ community, bringing to the marketplace a previously unavailable, afford- phono source. ground wire to mixer ground able combination of user-friendly, functional design, rugged construction, and pro- termin

Resumo do conteúdo contido na página número 3

D E S C R I P TION OF F U N C TI O N S 9. Headphone output: Connection for 1/4 inch headphone. Recommended headphone impedance is 32-200 ohms for maximum volume. 10. Cue pan: Fades the headphone output between the channel(s) selected by the cue assign switches (15) and the master one output, effectively allowing the user to pre- view a mix. 11. Crossfader source selectors: When set to A, the selecte channel will be assigned to the left side of the crossfader. when set to B, the selected channe

Resumo do conteúdo contido na página número 4

T E C H N I C A L S P E C I FI C AT I O N S Line inputs: 8 (RCA), 150 mV / 27K ohm Phono inputs: 4 (RCA), 3 mV / 47K ohm DJ mic input: 3 (XLR, 1/4Ò), 2.45 mV / 3K ohm Master output: 1 (RCA), 1.2 V / 1K ohm Record output: 1 (RCA), 245 mV / 10K ohm Headphone output: 1 (1/4Ó), 32 - 200 ohms recommended Frequency Response: 20 Hz - 20 kHz, +/- 2 dB Tone Control : + 9/-26 dB (Hi, Mid, Low) Mic Tone: Hi/Mid/Lo +/-10 dB Gain Control: 0-20dB S/N Ratio: Less than 70dB T.H.D: less than 0.2% Dimension(