Instrukcja obsługi Stanton RM-80

Streszczenie treści zawartej na stronie nr. 1

FADER CLE A N I N G
The RM-80 faders may need lubrication from time to time. This will extend the
fader life and eliminate any potential damage due to extended heavy usage.
RM-80 Professional performance mixer
Cleaning Instructions
1. Remove the fader and disconnect the cable coming from the mixer. To remove
the crossfader, unsecrew the outer screws (removing the 2 inner screws will
detach the fader from the fader plate). To remove the line faders, remove all 4
screws.
2. Spray a small amount of

Streszczenie treści zawartej na stronie nr. 2

T RO U B LE S H O OT I N G Thank you for making Stanton your first choice in professional DJ mixers. Problem Cause Solution This new, innovative family of mixers has been developed with input from the profes- Excessive hum when using Poor ground connection. Properly connect turntable sional DJ community, bringing to the marketplace a previously unavailable, afford- phono source. ground wire to mixer ground able combination of user-friendly, functional design, rugged construction, and pro- termin

Streszczenie treści zawartej na stronie nr. 3

D E S C R I P TION OF F U N C TI O N S 9. Headphone output: Connection for 1/4 inch headphone. Recommended headphone impedance is 32-200 ohms for maximum volume. 10. Cue pan: Fades the headphone output between the channel(s) selected by the cue assign switches (15) and the master one output, effectively allowing the user to pre- view a mix. 11. Crossfader source selectors: When set to A, the selecte channel will be assigned to the left side of the crossfader. when set to B, the selected channe

Streszczenie treści zawartej na stronie nr. 4

T E C H N I C A L S P E C I FI C AT I O N S Line inputs: 8 (RCA), 150 mV / 27K ohm Phono inputs: 4 (RCA), 3 mV / 47K ohm DJ mic input: 3 (XLR, 1/4Ò), 2.45 mV / 3K ohm Master output: 1 (RCA), 1.2 V / 1K ohm Record output: 1 (RCA), 245 mV / 10K ohm Headphone output: 1 (1/4Ó), 32 - 200 ohms recommended Frequency Response: 20 Hz - 20 kHz, +/- 2 dB Tone Control : + 9/-26 dB (Hi, Mid, Low) Mic Tone: Hi/Mid/Lo +/-10 dB Gain Control: 0-20dB S/N Ratio: Less than 70dB T.H.D: less than 0.2% Dimension(