Resumo do conteúdo contido na página número 1
Basic Useful
Introduction Easy Start Setup Connections Appendix
Operation Features
DATA PROJECTOR
MODEL
XG-SV100W
XG-SV200X
OPERATION MANUAL
Resumo do conteúdo contido na página número 2
IMPORTANT • For your assistance in reporting the loss or theft of your Projector, please record Model No.: the Model and Serial Number located on the bottom of the projector and retain this Serial No.: information. • Before recycling the packag ing, please ensure that you have checked the con- tents of the carton thoroughly against the list of “Supplied accessories” on page 11. ii
Resumo do conteúdo contido na página número 3
SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fi tted with a non-rewireable (moulded) plug incorporating a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refi t the fuse cover after replacing the fuse. Never use the plug without the fuse cover fi tted. In the unlikely event of the socket outlet in your home not being com
Resumo do conteúdo contido na página número 4
The supplied CD-ROM contains operation instructions in English, German, French, Spanish, Italian, Dutch, Swedish, Portuguese, Chinese, Korean and Arabic. Carefully read through the operation instructions before operating the projector. Die mitgelieferte CD-ROM enthält Bedienungsanleitungen in Englisch, Deutsch, Französisch, Spanisch, Italienisch, Niederländisch, Schwedisch, Portugiesisch, Chinesisch, Koreanisch und Arabisch. Bitte lesen Sie die Bedienungsanleitung vor der Verwendung des Proj
Resumo do conteúdo contido na página número 5
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Project or, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefi t of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptl
Resumo do conteúdo contido na página número 6
INFORMATION This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the operation manual, may cause harmful interference to radio communications.
Resumo do conteúdo contido na página número 7
Introduction How to Read this Operation Manual ■ The specifi cations are slightly different, depending on the model. However, you can connect and operate all models in the same manner. • In this operation manual, the illustration and the screen display are simplifi ed for explanation, and may differ slightly from the actual display. Using the Menu Screen RETURN button • Press RETURN to return to the previous screen when the menu is displayed. ENTER button Adjustment buttons (P/R/O/Q) MENU butt
Resumo do conteúdo contido na página número 8
Contents Preparing Displaying the Black Screen and Introduction Turning Off the Sound Temporarily ....... 35 Resize Mode .......................................... 36 How to Read this Operation Manual ......3 Contents .................................................4 Useful Features IMPORTANT SAFEGUARDS ..................6 How to Access the PDF Operation Operating with the Remote Control......40 Displaying and Setting the Manuals..............................................10 Break Timer ...
Resumo do conteúdo contido na página número 9
Introduction Auto Restart Function ............................. 56 COMPUTER2 Select .............................. 56 STANDBY Mode ..................................... 56 Selecting the Transmission Speed (RS-232C) ........................................... 56 Fan Mode Setting ................................... 57 System Lock Function ............................ 57 Keylock Function .................................... 58 ® TM DLP Link ............................................ 58 ® TM DLP
Resumo do conteúdo contido na página número 10
IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and servicing.
Resumo do conteúdo contido na página número 11
Introduction e. If the product has been dropped or 15. Overloading damaged in any way. Do not overload wall outlets, extension cords, f. When the product exhibits a distinct or integral convenience receptacles as this change in performance, this indicates a can result in a risk of fi re or electric shock. need for service. 16. Object and Liquid Entry 19. Replacement Parts Never push objects of any kind into this When replacement parts are required, be product through openings as they may t
Resumo do conteúdo contido na página número 12
Observe the following safeguards when setting up your projector. Caution concerning the lamp unit When using the projector in high- ■ Potential hazard of glass particles if lamp altitude areas such as mountains (at ruptures. In case of lamp rupture, contact altitudes of approximately 1,500 your nearest Sharp Authorized Projector meters (4,900 feet) or more) Dealer or Service Center ■ When you use the projector in high-altitude for replacement. areas with thin air, set “Fan Mode” to See
Resumo do conteúdo contido na página número 13
Introduction Caution regarding usage of the projector Using the projector in other countries ■ If you are not to use the projector for a long ■ The power supply voltage and the shape of time or before moving the projector, make the plug may vary depending on the region certain you unplug the power cord from the or country you are using the projector in. wall outlet, and disconnect any other When using the projector overseas, make cables connected to it. sure you use an appropriate power cord
Resumo do conteúdo contido na página número 14
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM. To ® ® utilize these manuals, you need to install Adobe Reader on your computer ® ® (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : Insert the CD-ROM in the CD-ROM drive. Insert the CD-ROM in the CD-ROM drive. Double click the “My Computer” icon. Double click the “CD-ROM
Resumo do conteúdo contido na página número 15
Introduction Accessories Supplied accessories Two R-6 batteries (“AA” size, UM/SUM-3, RGB cable HP-7 or similar) (10' (3.0 m)) Remote control Terminal cover Power cord* (1) (2) (3) (4) For U.S. and For Europe, For U.K. and For Australia, New Canada, etc. except U.K. Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) (6' (1.8 m)) * Which power cords are suppli
Resumo do conteúdo contido na página número 16
Part Names and Functions Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10 11 11 12 12 13 13 14 14 19 19 15 15 16 16 17 17 18 18 19 19 20 20 41 Side View 10 AUTO SYNC button For automatically adjusting images when 1 STANDBY/ON button 27 connected to a computer. For turning the power on and putting the 11 ECO+QUIET button 40 projector into Standby mode. For lowering the noise of the cooling fan
Resumo do conteúdo contido na página número 17
Introduction 12 12 33 44 55 66 77 88 99 10 10 11 11 12 12 13 13 14 14 15 15 16 16 17 17 Rear View (Terminals) 1 LAN terminal 26 9 HDMI terminal 22, 23 Terminal for controlling the projector using a Terminal for HDMI input. computer via network. 10 RS-232C terminal 25 2 USB terminal 42 Terminal for controlling the projector using Terminal connecting with the USB terminal a computer. on the computer for using the supplied 11 VIDEO input terminal 23 remote control as the computer mous
Resumo do conteúdo contido na página número 18
Part Names and Functions (Continued) Numbers in Z refer to the main pages in this operation manual where the topic is explained. 1 10 L-CLICK/EFFECT button 42, 40 • For the Left click when with the USB connection (using a USB cable). 2 • For changing the pointer or spot area. 3 30 11 ZOOM buttons For adjusting the projected image size. 12 ROTATE button 4 For setting the rotation angle of the projector 16 5 when the ceiling-mount rotating module (AN-SV100T) is connected. 6 17 41 13 MAGNIFY b
Resumo do conteúdo contido na página número 19
Introduction Inserting the Batteries Pull down the tab on the cover and remove the 1 1 cover towards the direction of the arrow. Insert the batteries. 2 2 • Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment. Insert the upper tab of the cover into the opening, 3 3 and lower the cover until it clicks in place. Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below Caution • Danger o
Resumo do conteúdo contido na página número 20
Easy Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 8 STANDBY button 3, 8 STANDBY/ON button 6, 7 ENTER button 3 ON button 6R/P buttons, 7 INPUT buttons 7 HDMI, COMPUTER 1/2, 6O/Q buttons S-VIDEO, VIDEO buttons 6 KEYSTONE button 4, 6 Adjustment buttons (P/R/O/Q) 6 ENTER
