ملخص المحتوى في الصفحة رقم 1
Keeping Keeping
Keeping Keeping Keeping
North North North North North America W America W America W America W America Warm arm arm arm arm
Since 1869 Since 1869 Since 1869
Since 1869 Since 1869
CORN & PELLET MULTIFUEL STOVE
6037
OWNER’S MANUAL
Installation - Operation - Maintenance Instructions - Repair Parts
READ THIS ENTIRE MANUAL, THOROUGHLY, BEFORE ATTEMPTING TO INSTALL AND/OR
BURN YOUR NEW AMERICAN HARVEST CORN AND PELLET MULTI-FUEL STOVE. FAILURE TO
FOLLOW THESE INSTRUCTIONS MAY RESULT IN
ملخص المحتوى في الصفحة رقم 2
CONGRATULATIONS! You've purchased one of America's Finest Multifuel Burning Stoves. By heating with fuels such as corn and pellets, you're helping CONSERVE AMERICA'S ENERGY! NOTE: YOUR UNIT MUST BE INSTALLED BY A QUALIFIED INSTALLER, such as an NFI Certified Specialist We strongly suggest installing smoke detectors in your home if not already installed. Initial burn off may cause slight smoke and odor the first few hours of operation. SPECIFICATIONS United States Stove Company (manufacturer o
ملخص المحتوى في الصفحة رقم 3
SAFETY STEPS IMPORTANT: Proper installation of this stove is necessary for safe and efficient operation. Installing this product improperly may result in a house fire and personal injury. All applicable building codes for your location must be followed. In areas where building codes require additional steps to the installation of this product not included in this manual the building codes will take precedent and must be followed. Contact your local building inspector to obtain any necessary
ملخص المحتوى في الصفحة رقم 4
BURNING SOLID FUELS continued... SHELLED CORN (Dry, preferably corn with 11- 12% moisture content) • Corn must contain less than 14% moisture content. Wet corn will rapidly deteriorate stove components, reduce efficiency and void all warranties. Purchase a moisture tester if in doubt. • Corn must be clean and free from debris. Never burn corn right from the field. Damage caused by dirty corn is not covered by the product warranty. Ask for clean filtered bagged corn only. Stalk parts, exces
ملخص المحتوى في الصفحة رقم 5
CLEARANCES TO COMBUSTIBLES The stove must be installed with the following minimum clearances to side and back wall combustible materials. NOTE: These are minimum clearances to combustible walls established by the testing lab. The amount of room needed on the left side of the unit to access the electrical panel is (6) six inches (152mm). PARALLEL - A - Left Sidewall to Top Edge of Unit 6 in./152mm B - Sidewall to Flue 5 in./127mm C - Backwall to Flue 3 in./75mm D - Backwall to Unit 9 in./228mm
ملخص المحتوى في الصفحة رقم 6
GUIDELINES FOR EXHAUST VENTING SYSTEMS DESIGN It is recommended that only an authorized installer install your pellet/corn stove, preferably an NFI certified specialist. The following installation guidelines must be followed to ensure conformity with both the safety listing of this stove and to local building codes. INSTALL VENT AT CLEARANCES SPECIFIED BY THE VENT MANUFACTURER. • A UL listed 3” or 4” type “PL” pellet vent exhaust system must be used for installation and attached to the pipe c
ملخص المحتوى في الصفحة رقم 7
DESIGN GUIDELINES FOR OUTSIDE COMBUSTION AIR CONNECTION 1) For installations with horizontal through-the-wall exhaust, it is strongly recommended that the stove combustion air be connected to the outside. If the home is newer or has been tightly insulated it is required to install outside combustion air. 2) Connection to outside the house is REQUIRED for mobile home installations. We strongly urge use of the 67FAK Fresh Air Kit. 90 DEGREE BEND TERMINATION WIND HOOD TERMINATION Wind Hood 2” Min
ملخص المحتوى في الصفحة رقم 8
INSTALLATION CONFIGURATIONS Note: Where passage through a wall, or partition of combustible construction is desired, the installation shall conform to CAN/CSA -B365 The American Harvest Corn/Pellet Stove Model 6037 may be installed as follows: 1) A freestanding unit MOBILE HOME INSTALLATION REQUIREMENTS IN ADDITION TO THE STANDARD INSTALLATION INSTRUCTION, THE FOLLOWING REQUIREMENTS ARE MANDATORY FOR INSTALLATION IN A MOBILE HOME: WARNING DO NOT INSTALL IN SLEEPING ROOM 1) Stove must be perma
ملخص المحتوى في الصفحة رقم 9
FREESTANDING STOVE INSTALLATION REQUIREMENTS Horizontal Exhaust Termination: Locate proper position for the type “PL” wall thimble (F). 1) Use a saber saw or keyhole saw to cut a 7 1/4-inch diameter hole through the wall (E) for a 3-inch pipe. For a 4-inch 2) pipe, cut an 8 1/4-inch hole. Install the wall thimble (F)in the hole. The size of hole opening will vary with brand of wall thimble. Position stove approximately 12” from the wall on the noncombustible floor pad. Push the type “PL” pip
ملخص المحتوى في الصفحة رقم 10
Termination Cap NOTE: Vertical Pipe must be 4” PL Above 4’ 9” Min. Support Bracket Wall Thimble Tee Clean Out Cover 6” Min. Fresh Air Intake (Optional 67FAK) With 90 Degree Elbow or Hood (Pest Guard, 3/8” Mesh Maximum) Non Combustible Hearth Plate The Hearth Pad is not required under the unit if the floor is noncombustible but is required 6 inches (152mm) beyond the front of the unit and 6 inches (152mm) beyond each side of the door. THROUGH THE WALL, VERTICAL PIPE INSTALLATION WITH TERMINATION
ملخص المحتوى في الصفحة رقم 11
GLASS MAINTENANCE, REMOVAL AND REPLACEMENT Your American Harvest Corn/Pellet Stove comes to you with the glass door installed in place, ready for use. The glass is surrounded on the edges with a gasket and seated in a glass channel. It is held in place with four (4) clips. REMOVAL OF BROKEN OR DAMAGED CERAMIC GLASS Open the door and lift off of hinges. If the door is tight, tap gently on the bottom of the door with your hand or rubber hammer. Lay door down on newspaper with glass clips facin
ملخص المحتوى في الصفحة رقم 12
STOVE CONTROLS Adjustable Door Handle lifts up and turns left to open. Ash Dump Shutoff Pull out to empty ashes out of the firebox area. Make sure to push all the way in when done. Front View Circuit Board Control Panel Left/Front View Manual Draft Adjustment Slide in or out to adjust the amount of draft flowing through the firebox. Service Note: For service needed inside the cabinet, remove the retaining screws at front and rear. CAUTION! Use care, panel is heavy. When removing either panel
ملخص المحتوى في الصفحة رقم 13
LIGHTING INSTRUCTIONS CAUTION: DO NOT USE CHEMICALS OR FLUIDS TO START THE FIRE HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING AND FURNITURE AWAY. CONTACT MAY CAUSE SKIN BURNS. Before lighting your American Harvest for the first time, make sure that all items are out of the hopper, ash pan and firebox area. Turn the heat settings knob to the High position and pull the manual draft out as far as it will go. Allow your American Harvest to run for at least 4 minutes to check for proper operati
ملخص المحتوى في الصفحة رقم 14
SETTING THE DRAFT A proper draft setting is crucial to the successful burning of solid fuels. Draft refers to the amount of air flowing through the burn chamber of your stove. Too much or too little draft will cause your stove to burn improperly and may result in the fire burning out or excessive deposits (clinkers). Please follow these guidelines carefully as you operate your stove to achieve maximum efficiency and enjoyment. • The amount of draft required for your stove to burn properly wil
ملخص المحتوى في الصفحة رقم 15
Maintenance Instructions Continued... SPECIAL CLEANING/OPERATIONAL INSTRUCTIONS: After cleaning or when operating the unit you need to make sure that the clean-out plates, the two inside the firebox and the two just un- der the firebox on the front of the unit, are in the closed position. Push the front (2) clean- Cleanout Plates out slides all the way in and make sure that you have replaced the left & right clean-out plates that are located on the inside of the unit (these plates are located i
ملخص المحتوى في الصفحة رقم 16
AUTOMATIC SAFETY FEATURES WARNING These automatic safety features must not be bypassed • Power Outage During a power outage, the stove will shut down safely. It will not automatically restart when the power returns, unless the exhaust is still up to temperature (see “Lighting Instructions” page 16). • Overheating A high temperature switch will automatically shut down the stove if it overheats. The stove will need to be manually relit. Allow 45 minutes before relighting. • Auger Guard A heavy g
ملخص المحتوى في الصفحة رقم 17
CIRCUIT BOARD FUNCTIONS START-UP SEQUENCE OF EVENTS Once the control panel is turned to one of the five heat settings, a timer begins that will start, stop and continue operation of the American Harvest as a preset temperature is achieved. COMPONENT OPERATION START OPERATION END Exhaust Blower Starts Immediately Will continue until shutdown. Shutdown will occur when the operating tempera- ture is below 90 degrees. Agitator Three minutes after starting the agita- Will continue intermittingly, has
ملخص المحتوى في الصفحة رقم 18
CIRCUIT BOARD FUNCTIONS continued... SHUTDOWN SEQUENCE OF EVENTS Once the AMERICAN HARVEST has reached the normal operating temperature and switched to the “OFF” position, the unit will continue to operate on a much lower setting for 10 minutes. (Approximately half of the “1” setting). After 10 minutes the auger will slow down further and continue at this feed rate until the AMERICAN HARVEST “LOW LIMIT SAFTEY” sensor tells the control board it is safe to shutdown. COMPONENT SHUTDOWN OPERATION EN
ملخص المحتوى في الصفحة رقم 19
TROUBLE SHOOTING Unplug stove before performing any maintenance PROBLEM CAUSE: Too rich air/fuel mixture ? Fire burns with a lazy, orange flame ! Increase air by pulling out air ! Check inside stove and exhaust and/or fuel builds up in the firepot. damper. pipes for blockage. Tap inside Glass may become dirty. walls of firebox, clean behind ! Make sure glass door is shut and lower access plates (located on sealed tightly. If not, adjust door the back inside wall, next to the handle or replace ga
ملخص المحتوى في الصفحة رقم 20
WIRING DIAGRAM 20 USSC
