Koss JR/900 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

http://koss.com/koss/kossweb.nsf/pmbyunid/695B97328E3F9565862567...
Print
Close This Window
Congratulations on your choice of the Koss JR/900 Cordless RF Stereophone System. Now you can enjoy the
Sound of Koss anywhere in your home- even outdooors-without the cord. The Koss JR/900 RF System
Includes:
1. KossJR/900S Stereophones (1)
2. Koss JR/900T Transmitter (1)
3. Koss JR/900A Adapter (1)
4. 3.5 mm male stereo plug to dual RCA stereo plug connecting cord.
5. DC male to DC male recharge cord
6.

ملخص المحتوى في الصفحة رقم 2

http://koss.com/koss/kossweb.nsf/pmbyunid/695B97328E3F9565862567... to any of the following frequencies by moving the switches. JR/900S STEREOPHONE CONTROLS ON/OFF Switch Place this switch in the ON position when using the stereophones. Place the switch in the OFF position when you are charging the battery pack or when you are charging the battery pack or when the stereophones are not in use. Recharge Jack Located at the bottom right earcup. The recharge cable from the transmitter connects here

ملخص المحتوى في الصفحة رقم 3

http://koss.com/koss/kossweb.nsf/pmbyunid/695B97328E3F9565862567... listening life of approximately 10 hours. The NICAD battery pack must be fully charged prior to operation. An initial charge of 24 hours is required to ensure the extended life of the NICAD battery pack. When charging, be sure the stereophone is off. These batteries are located inside the stereophone and do not need to be removed to be recharged. The red/green LED on the stereophone will extinguish when battery power is low. The

ملخص المحتوى في الصفحة رقم 4

http://koss.com/koss/kossweb.nsf/pmbyunid/695B97328E3F9565862567... cause interference to radio or television reception, which you can determine by monitoring reception when the JR/900 Stereophone System is installed and when it is removed from the sound system, try to correct the problem with one or more of the following measures: *Reorient the receiving antenna. *Relocate the signal source with respect to the receiver. *Relocate the signal source and/or the receiver so that they are on separat