ملخص المحتوى في الصفحة رقم 1
PLAY/STOP
CLOCK
CHARGING
MEMO/REWIND FAST FWD SAVE
HANDSET IN USE
User's Manual
for Cordless Answering
System Telephone 7610
Fold open this manual for information about this
telephone's installation and operation. Please
read Part 1 – Important Product Information,
included in this package
Part 2
© Copyright 1997 Lucent Technologies, Inc. All rights reserved.
Printed in Mexico. Issue L4
847868304
VOLUME
ملخص المحتوى في الصفحة رقم 2
aaaaaaaaa aaaaa aaaaa aaaaaaaa INST ALLA TION Standard AC Outlet Modular Wall Jack AC Adapter Telephone Line Cord Power Cord 1 Insert the microcassette. track up over the battery case groove on the bottom of the base.) Lift the cover and insert the until it snaps firmly in place. Plug the other end of the line cord microcassette with the full reel to into a modular phone jack. Make the right. 4 Set the Handset Ringer ON/OFF sure the plug snaps firmly in place. switch. Set the switch on the side
ملخص المحتوى في الصفحة رقم 3
PLAY/STOP CLOCK CHARGING MEMO/REWIND FAST FWD SAVE HANDSET IN USE aaaaaa aaaaaaaa aaaaaaaaa aaaaa INST ALLA TION Base Antenna (extended) Cover Turn system on or off. Lift panel door to access features Record or play (see figure at right). outgoing anouncement Audible clock; also use with CHANGE to set time/day. Use with other buttons to Adjust message playback volume. change settings Fast forward during message Play messages or playback. stop message playback Save messages. should be on steady.
ملخص المحتوى في الصفحة رقم 4
aaaaaaaaaaaaaaaaaaa a a a aaaaaaaaaaaaaaaa BA TTERIES CAUTION: To reduce the risk of Replacing the Handset Charging the fire or injury to persons or Battery Pack Handset Battery Pack damage to the telephone, read and follow The batteries need charging when: 1 Remove the battery case cover on these instructions carefully. • The phone beeps four times when you the handset by pressing on the • Use Lucent Technologies Replace press P. indentation and sliding the cover ment Battery 4051 in the
ملخص المحتوى في الصفحة رقم 5
aaaaaaaaa a aaaaaaaaa IN CASE OF DIFFICULTY If you have difficulty operating this phone, • Place the handset in the base, • Make sure the base antenna is upright. try the suggestions below. If you still have and check to make sure the • Disconnect the base from the tele- trouble, call Lucent Technologies at CHARGING light is on. phone jack and plug in a corded 1 800 222-3111. Unplug the AC adapter from the telephone. If you still hear noise or outlet, wait 15 seconds, then plug interference, the
ملخص المحتوى في الصفحة رقم 6
a a aaaaaaa a a aaaaaaa IN CASE OF DIFFICULTY • Try sliding the Volume control on the If the system does not respond to remote If you have difficulty hearing messages side of the base upward to increase commands • If messages are garbled, the recording volume. • Make sure you are calling from a heads may be soiled and should be touch tone telephone. If you hear cleaned. If the recording tape sticks or malfunctions clicks when you dial, the phone is not • Unplug the system from the • Use only hi
ملخص المحتوى في الصفحة رقم 7
aaaaaaaaaaaaaa aaaa aaaaaaaaaaaaaaaaaa OPERA TION to the base for recharging. You can still use Making A Call the handset to make a call or to answer a call 1 Press P, and wait for the if you hear an extension phone ringing. PHONE light to go on steadily. 2 When you hear a dial tone, dial the When the ringer ON/OFF switch is set to number. ON, the handset stays ready to use for up to 14 days in standby mode. NOTE: You might experience a slight de- lay before you hear a dial tone, as the ® Hand
ملخص المحتوى في الصفحة رقم 8
aaaaaaaaaaaa aaaaaaaaaaa aaaaaaaaaaaaaaa aaaaaaaa MEMOR Y This cordless phone can store 10 telephone NOTE: Each pause you store is counted as numbers that you can dial just by pressing a digit. You can store up to 16 digits in each p and one of the number buttons. memory location. Additionally, the 7610 offers a memory lo- For example, to store 9, PAUSE, cation accessed by pressing m. 555-1234 in memory location 3: Press p, 9, (hold the 9 Storing Speed-Dial Numbers for 2 seconds, until a second
ملخص المحتوى في الصفحة رقم 9
a a aaaaaa a a a aaaa OPERA TING RANGE This cordless telephone operates at the If you move out of range during a phone Changing Channels maximum power allowed by the Federal conversation, you will hear noise or inter- This cordless telephone has an advanced Communications Commission (FCC). ference. To improve reception, move closer ® 25-channel AutoSelect feature that mini- Even so, the handset and base can com- to the base. mizes the chance of interference. Every municate over only a certain d
ملخص المحتوى في الصفحة رقم 10
PLAY/STOP CLOCK CHARGING MEMO/REWIND FAST FWD SAVE HANDSET IN USE a aaaaaaaaaaa aaaaaaaaaaa a ANSWERING SYSTEM OPERATION Light goes on when handset is in use or battery is charging. Fast forward during message playback. Audible clock; also use with CHANGE (under the cover) to set time/day. Blinking light indicates messages are waiting. Play messages or stop Record a memo, or message playback rewind tape during message playback Save Adjust message playback volume. messages. 2 Press and release g
ملخص المحتوى في الصفحة رقم 11
aaaaaaaaaaa a aaaaaaa aaaaa ANSWERING SYSTEM OPERATION played back with other messages. Ring Select Listening to Your Messages MEMO/REWIND 1 Hold down . After Use the Ring Select switch on the back side Before listening to your messages, set the the beep, speak toward the front of the base unit to select how many times message volume control so you can hear of the base. the line will ring before the system answers PLAY/STOP the messages. When you press the 2 To stop recording, release a call.
ملخص المحتوى في الصفحة رقم 12
aaaaaaaa aaaa aaaaaaaaaaa a ANSWERING SYSTEM OPERATION 3 After the two beeps, wait 4 FROM A REMOTE Recording a New seconds, and the system plays TOUCH TONE PHONE Announcement back messages 1 Press 7, * after the two beeps. — OR — You will hear a series of short Remote Access Code Press and release 1 to play beeps, then one long beep. all of your messages (if there The Remote Access Code is a 3-digit code 2 After the long beep, record your are no messages, the system which lets you access your 76
ملخص المحتوى في الصفحة رقم 13
Answering System 7610 Operation From a Remote Touch Tone Phone To access your answering system: 1 Dial your telephone number. 2 When the system answers, enter your 3-digit Remote Access Code. The system announces the number of messages received, then beeps twice and is ready to accept a command. See the other side of this card for a complete list of remote commands. © 1997 Lucent Technologies, Inc. All rights reserved. Printed in Mexico. Issue 1. 847875440 Answering System 7610 Operation Fro
ملخص المحتوى في الصفحة رقم 14
COMMAND PRESS Play all messages 1 2 Play only new messages 1 Replay messages after playing messages Rewind Hold down 4 ; release to play. 6 Fast Forward Hold down ; release to play. 3 3 Clear messages , . Stop 5 ; press 1 to play.. 7 Record announcement , , speak after long beep, 5 press to stop. Change Remote Access Code 9 , 9 , enter new code. 0 Turn system on 8 8 Turn system off , COMMAND PRESS Play all messages 1 Play only new messages 2 Replay messages 1 after playing messages
ملخص المحتوى في الصفحة رقم 15
ملخص المحتوى في الصفحة رقم 16
ملخص المحتوى في الصفحة رقم 17
ملخص المحتوى في الصفحة رقم 18
ملخص المحتوى في الصفحة رقم 19
ملخص المحتوى في الصفحة رقم 20
