Philips MCD288E دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

1
Connect the speaker (subwoofer) cables.
Tips
– See the User Manual for other TV
2
connection options.
Connect the FM antenna.
–For connecting to a Progressive Scan
TV, refer to the user manual for proper
3
connections and detailed setup.
Connect the A/V cord to a TV.
–Never connect the AC power cord
before connection of the DIN cable to
avoid causing any damage to the set.
4
Connect the power cords of the system and TV.
AC power
S-VIDEO
IN
AUDIO
TV IN
IN
VIDEO IN
4
S-VIDEO
AUDIO IN IN TV IN
V

ملخص المحتوى في الصفحة رقم 2

Setting the clock IMPORTANT! – To set clock in the Eco Power mode, press and hold STANDBY-ON/ECO POWER 2 on the set for 3 seconds or more to switch to normal standby mode first before proceeding with the procedures below. 1 In standby mode, press and hold CLOCK on the system. 2 When the hour digits flash, press VOLUME-/+ (VOL+/- on the remote control) to set the hours. 3 Press CLOCK again and the minute digits flash. Then press VOLUME-/+ (VOL+/- on the remote) to set the minutes. 4 Press CLOCK

ملخص المحتوى في الصفحة رقم 3

P r i n t Playing a disc 1 Insert a disc into the slot loader. ➜ Make sure the label side is facing you. ➜ Make sure you have removed any other disc from the slot loader. 2 Playback will start automatically. If not pressÉÅ. 3 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote control) to select tuner source. 2 Press PROGRAM on the remote control for more than two seconds to program all available stations in order of waveband. 3 Press PRESET ¡