ملخص المحتوى في الصفحة رقم 1
Instructions for use
_vox
3135 015 104O1
ملخص المحتوى في الصفحة رقم 2
Once your PHILIPS MAGNAVOX purchase is registered, you're eligible to receive all the privileges of owning a PHILIPS MAGNAVOX product. So complete and return the Warranty Registration Card enclosed with your purchase at once. And take advantage of these important benefits. Congratulations on your purchase, PHILIPS and welcome to the "familyF' Dear PHILIPS MAGNAVOX product owner: Thank you for your confidence in PHILIPS MAGNAVOX. You've selected one of the best-built, best- backed products availa
ملخص المحتوى في الصفحة رقم 3
SAFETY INSTRUCTIONS - Readbeforeoperatingequipment This product was designed and manufactured to meet strict quality and 11. Power-Cord Protection - Power supply cords should be routedso safety standards. Thereare, however, some installation and operation pre- that they are not likely to be walked on or pinched by items placed cautions which you should be particularly aware of. upon or against them, paying particular attention to cordsand plugs, convenience receptacles, and the point where they
ملخص المحتوى في الصفحة رقم 4
Introduction Here are a few of the special features built into this new Color Television: Welcome/Registration of Your TV ............................ 2 Safety/Precautions ..................................................... 3 SmartLock TM feature allows you to block the view- Table of Contents ....................................................... 4 ing of certain channel or external audio/video con- Features ...................................................................... 4 nections wh
ملخص المحتوى في الصفحة رقم 5
yhur Cable TV input into your Remember: ! ome may be a single (75 Set the TV for the ohm) cable, or a Converter Box installation. In either case the type signal you've connection to the 71/is very easy. just connected (see the "Tuner section Just put the threaded end of the on page 11 of this cable signal to the TV's antenna manual.) plug and screw it down tight. To select only the is sin- channel numbers on <_Ifyour Cable TV signal a gle round cable (75 ohm) then your Cable system you're ready
ملخص المحتوى في الصفحة رقم 6
U-3 combination antenna receives Lnormal broadcast channels Remember: Be sure to set the (VHF 2-13 and UHF 14-69). Note: For homes with separate UHF and VHF antennas TV for the type sig- Your connection is easy since you will need an optionalcombiner to connect to the TV. nal you've connect- there is only one 75f2 (ohm) ed (see the "Tuner" u/v antenna plug on the back of your Combiner section on page I 1 TV - and that's where the antenna of this manual.) <. goes. To set the TV to round <_ lfyour
ملخص المحتوى في الصفحة رقم 7
TTv,he basic Antenna, or Cable to VCR to TV connection is shown to the right. For more information on other hookups (possible when Cable Converter/Descrambler boxes are included) refer to your accessory VCR and Cable Converter Owner's Manual for details. _ Connect your Antenna or Cable TV signal to the IN FROM ANT(enna) plug on the VCR. OUT TO TV <_ Connect the plug on the VCR to the 75£2 plug on the TV (connecting cable supplied with the VCR.) ! !i!i!i!i!i!i!i!i!i!i!i!i!i!i!iiiii!i!iii!i!iiii
ملخص المحتوى في الصفحة رقم 8
7-7 button _ Press the POWER to turn the TV ON. but- Press the VOLUME + • ton to increase the sound level or the VOLUME 41- button to lower the sound level. Pressing both buttons at the same time will display the onscreen menu. Once in the menu, use these button to make adjustments or selections. Press the CHANNEL UP • or < DOWN • button to select TV channels. @ Cx:3Cx3 LMENO_ Remote Sensor Window Headphone Jack Ti o load the supplied batteries nto the remote." 1. Remove the battery compart- men
ملخص المحتوى في الصفحة رقم 9
Power Button Press to turnthe TV ON and OFF. Press to set the TV to automatically turn itself OFF. cc Button Press to select Closed Caption options within the menu. Clock Button Press for direct entry of the TIMER (Clock) features were you can set the TV's clock, the Start Time, and the Start Channel Controls. ® ® @ Number Buttons Press the number buttons to select TV channels. For single digit entries, )tess the number of the channel you desire. The TV will pause for a few seconds, then change
ملخص المحتوى في الصفحة رقم 10
7q F_n r our Spanish and French speak- g TV owners an onscreen LAN- GUAGE option is present. With the LANGUAGE control you can set the TV's onscreen menu to be shown in either English, Spanish, or French. <_ Press the MENU button on the I remote to show the onscreen menu, _ Press the CURSOR UP • or I_uP • I SmactLock[:_AEW • DOWN • buttons to scroll through the onscreen menu until the word BFIK:_Tf, ESS 1.....-. 30 TUNER CABLE SETUP s high ghted. AUTOPROGRAM • _,_ Press the CURSOR RIGHT • button
ملخص المحتوى في الصفحة رقم 11
Tche TUNER feature allows you to hange the TV s signal input to either CABLE, AUTO or ANTENNA mode. It's important for the TV to know what type of signal to look for: (From a Cable TV signal or a normal Antenna signal.) In the AUTO mode, when the AUTO PROGRAM feature is activated, the TV will automatical- ly choose the correct mode. o_ OFF IsEtup •1 on _ Press the MENU button the Sma-t:Lock REVIEW • LANGUAGE BIRIGHTNES8 l'....... 30 remote to show the onscreen menu. ITUNm I _ Press the CURSOR UP
ملخص المحتوى في الصفحة رقم 12
7-3 1. -- Vour TV can automatically set itself| for local area (or Cable TV) chan- | nels. This makes it easy for you to I select only the TV stations in your 1 area when the CHANNEL (+), (-) but- | tons are pressed, l Note: Make sure the antenna or cable I signal connection has been completed [ before AUTO PROGRAM is used. I O_OOK • cc Gq: I <_ Press the MENU button on the ] ]SEIUO • I remote to show the onscreen menu. • SmartLock[:r_MIEVV • 13_ Ira-,,,,, 30 I I '_ Press the CURSOR UP • or I _
ملخص المحتوى في الصفحة رقم 13
i Channel Edit makes it easy for you to ADD or DELETE channels from the list of channels stored in the TV's memory. <_ Press the MENU button on the remote to show the onscreen menu. <_ Press the CURSOR UP • or CLOCK • DOWN • buttons to scroll through (_3 OFF the onscreen menu until the word I -TUp • I TUNER r_BLE SmartLockREVIEW • SETUP s h gh ghted. AUTOPROGRAM • BRIGHTNESS l'""'" <_ Press the CURSOR RIGHT • tr- NEL •l EXTERNAL • button to display the SETUP menu features. <_ Press the CURSOR U
ملخص المحتوى في الصفحة رقم 14
you to rename your input source selec- tions. When the Input feature (refer to Owner's Manual for details) is accessed to change audio/video jacks, your source selection will be called by the name you choose. This name will also appear onscreen when using the audio/video inputs. AUTO_ • _ Press the MENU button on the CHANNELEDIT • remote to show the onscreen menu. I •I <_ Press the CURSOR UP • or DOWN • buttons to scroll through the onscreen menu until the word SETUP s high ghted. <_ Press the C
ملخص المحتوى في الصفحة رقم 15
I trois, select a channel and follow the steps shown below: --_ T o adjust your TV picture con- ¢-ffga_) MENU button the Press the on I remote to display the onscreen menu. .... _iiiiiiiiiiiiiiiiiiiiiii_ii_ii_i_iiiii!_iiii_i_iiiiiiiiiiiiiiiiiiiiiiiii_iii_i:iiii_i_i_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_@iiiiiiiiiiiiiiiiiiiiiiiiii_i_!_:_iii_ ...... '_ Press the CURSOR UP • or _-rup • DOWN • buttons until the word SmaCk _ • BRIGHTNESS is highlighted. (Or, I_I_E_ m .......30I COLOR, PICTURE, SHARPNESS,
ملخص المحتوى في الصفحة رقم 16
ES3 tretch Tfehe Contrast Plus (Black ature helps to "sharpen the picture quality. The black portions of the picture become richer in dark- ness and the whites become brighter ,_ Press the MENU button on the remote to display the onscreen menu. '_ Press the CURSOR UP • or TINT .......I........ 0 COL."i_IVlP CURSOR DOWN • buttons until "RNT .......! ....... 0 the words CONTRAST PLUS are I_ PLL_ 0FFI COL.TEMP NORMAL NOISEREDUCrI'ION ON h gh ghted. lCONTRA,Sq" PLL_ 0Nl VOLUME _. ....... 15 <_ Pre
ملخص المحتوى في الصفحة رقم 17
FOer reasons such as poor cable ception, the picture can some- times appear slightly "speckled" (or signal noise shown in the picture). The NOISE REDUCTION control can help eliminate this type of interference and improve the quality of the picture. <_ Press the MENU button on the I remote to display the onscreen menu. _MP _ <_ Press the CURSOR UP • or PL_ CURSOR DOWN • button until [NO the words NOISE REDUCTION are VOLUME i ....... 15 h gh ighted. _B_ _ OFF <_ Press the CURSOR RIGHT • or CURSOR
ملخص المحتوى في الصفحة رقم 18
C2 -- Vour television comes with an I onscreen clock. During normal operation the clock appears on the screen when the STATUS/EXIT but- ton is pressed or when channel changes occur <_ Press the CLOCK button on the remote to display the onscreen CLOCK menu. [SETOJXX <_;_ Press the CURSOR UP • OR qlMER ACTIVE ON CHANNEL 12 CURSOR DOWN • buttons until ISETCt_0CK 10:00 AMI the words SET CLOCK are high- TIMERACTME ON ghted, CHANNEL 12 <_ Enter the current time using the NUMBERED buttons. If the first
ملخص المحتوى في الصفحة رقم 19
7ust like an alarm clock you can LI set the TV to turn itself on at the same time ev_ Press the CLOCK button to I display the Clock onscreen menu. <_ Press the CURSOR UP • or CURSOR DOWN • button until the words TIMER ACTIVE are SETCLOCK 10:00 AM h gh ghted. I MERAC' OFF I <_ Press the CURSOR RIGHT SETCLI(3CK 10:00 AM I_ or CURSOR LEFT • button STAI=ff ]]ME - - : - - AM FnMERACT_ oNI to select ON (if activating) or OFF CHANNEL 12 if deactivating) the Timer control. START TIME -- : - -AM < Rememb
ملخص المحتوى في الصفحة رقم 20
E2 -- l" ped along with the Clock fea- _" lures, you can select a specific channel that the television will tune to when the Tinter Active control is S_T_ 10:00 AM turned ON. TIMER ACTM_ ON Remember: Be sure to set [CHANNEL 12[ START TIM_ - : - - AM a the Timer Active control to ON. <_ Press the CLOCK button to The onscreen menu will time out display the Clock onscreen menu. and disappear from the screen when <_ Press the CURSOR UP • or you finish, or you can press the < CURSOR DOWN • button unt
