Xerox Phaser Color Printer 8400 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Phaser® 8400 Color Printer
Windows NT 4.x
This topic includes:
■ "Preliminary Steps" on page 3-20
■ "Quick CD-ROM Install Steps" on page 3-20
■ "Other Methods of Installation" on page 3-21
■ "Windows NT 4.x Troubleshooting (TCP/IP)" on page 3-23
Preliminary Steps
These preliminary steps must be performed for all printers:
1. Verify that the printer is plugged in, turned on, and connected to an active network.
2. Verify that the printer is receiving network traffic by monitoring the LED’s on the

ملخص المحتوى في الصفحة رقم 2

Windows NT 4.x Other Methods of Installation Install your printer on a Windows NT network using one of these methods: ■ Microsoft TCP/IP protocol ■ Xerox TCP/IP Port Monitor The following methods can also be used to monitor or configure your printer: ■ A web browser using CentreWare IS if your printer is connected to a Windows NT network with TCP/IP protocol enabled. ■ The Xerox CentreWare MC snap-in to Microsoft Management Console for installing or managing multiple printers on a Windows NT

ملخص المحتوى في الصفحة رقم 3

Windows NT 4.x 3. Select the *.INF file, then click Open. Verify that the path and filename are correct, then click OK. 4. Select the correct printer, then click OK. 5. Enter a name for the printer, select whether you want that printer to be the default, then click OK. 6. Select one of these options: ■ If the printer is not shared, click Next. ■ If the printer is shared, enter a Share Name, check the Share box, then click Next. Printing a Test Page You are prompted to print a test page. 1. Se

ملخص المحتوى في الصفحة رقم 4

Windows NT 4.x Configuring the TCP/IP Printer Port The Xerox TCP/IP Printer Port Wizard guides you step-by-step through the following procedures: ■ Choosing a name for the new port ■ Identifying a printer by its DNS Name or IP Address ■ (Alternatively) Identifying a printer using the automatic Printer Discovery feature To install the printer port: 1. Click Next to proceed with the port installation. The wizard verifies the port name and printer address, then configures the remaining port setti

ملخص المحتوى في الصفحة رقم 5

Windows NT 4.x Verifying Settings 1. Verify the settings in the “Configuration Page.” ■ IP Address Source is set to: DHCP, Front Panel, BOOTP, or Auto IP (depending on your network configuration). ■ Current IP Address is set correctly. (Note this address if it is assigned by Auto IP, DHCP, or BOOTP.) ■ Subnet Mask is set correctly (if used). ■ Default Gateway is set correctly (if used). ■ LPR is enabled. Verify that the LPR and AppSocket settings are set as desired. ■ Interpreters: Auto, PCL,