Kodak 1K5857 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 45.00° 10/22/2009 7:58:56 PM AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 45.00° 10/22/2009 7:58:56 PM AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 0.00° 10/22/2009 7:58:56 PM AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 0.00° 10/22/2009 7:58:56 PM AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 75.00° 10/22/2009 7:58:56 PM AIO-Opal-Network Setup Guide-4Langhi.pdf 175.00 lpi 7

ملخص المحتوى في الصفحة رقم 2

Rotate MS SD/HC MMC Back Home urg_01108.book Page 1 Thursday, October 22, 2009 7:41 PM 1 Choosing a Connection Type Make sure you completed the steps in the Start Here Guide. Then choose one of the following connection types for your printer, and see the corresponding chapter for instructions. NOTE: • You can change your connection type later. See the chapter Configuring Your Printer in the Extended User Guide. • For additional networking information or troubleshooting, go to www

ملخص المحتوى في الصفحة رقم 3

urg_01108.book Page 2 Thursday, October 22, 2009 7:41 PM 2 Setting Up the Wireless (Wi-Fi) Connection Before you connect You need to: • Have a functional 802.11 wireless network. Kodak recommends that you use a wireless access point, most commonly a router, that uses Dynamic Host Configuration Protocol (DHCP). • Determine whether your wireless router supports Wi-Fi Protected Setup (WPS). • Temporarily disable your firewall until the printer is successfully installed and communicating. IMPOR

ملخص المحتوى في الصفحة رقم 4

urg_01108.book Page 3 Thursday, October 22, 2009 7:41 PM Setting Up the Wireless (Wi-Fi) Connection 4. If the name of your network is: Listed Not Listed Press to select Make sure your wireless router is turned on and within range. If your your network, then wireless router does not broadcast its SSID: press OK. a. Press to select Unlisted network, then press OK. b. Use the LCD keyboard to enter your network name. c. Select WEP or WPA/WPA2 as required for your network's security setup, th

ملخص المحتوى في الصفحة رقم 5

urg_01108.book Page 4 Thursday, October 22, 2009 7:41 PM 3 Setting Up the Ethernet Connection Before you connect You need to: • Have a functional Ethernet network that includes a router, switch, or hub with an Ethernet port. • Have a Category 5 (or higher) Ethernet cable. • Temporarily disable your firewall until the printer is successfully installed and communicating. Connecting to an Ethernet network 1. Connect the Ethernet cable into the Ethernet port on the back of the printer. 2. Connect

ملخص المحتوى في الصفحة رقم 6

urg_01108.book Page 5 Thursday, October 22, 2009 7:41 PM Eastman Kodak Company Rochester, NY 14650 © Eastman Kodak Company, 2009 Kodak is a trademark of Eastman Kodak Company. Specifications subject to change without notice. P/N 1K5857 October 2009 1K5857