Ingersoll-Rand Cylinder Removal and Re-Keying Kit BE365 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Cylinder Removal and Re-Keying Kit
Schlage Keypad Deadbolts come standard with a 5-pin solid
brass C-keyway cylinder. The re-keying steps are the same as
for the Schlage B-300 series deadbolt. Cylinder removal and
replacement instructions are illustrated on the back page.
A supplemental kit has been designed with replacement
parts for the Keypad Locks and Deadbolts.
Supplemental Re-Keying Kit
Part Number 38-030 Keypad Re-Keying Kit
Part Kit Reorder
Number Description Qty. Qty.
F605-367

ملخص المحتوى في الصفحة رقم 2

BE365 Cylinder Removal Instructions 1 5 Remove Backplate from Outside Keypad Assembly Rekey Cylinder as Usual 6 Install Spring, Pin, Tailpiece, and Cylinder Cap 2 Remove Cylinder from Thumbturn NOTE: Tailpiece is available in the Schlage Supplemental Electronics Lock Rekeying Kit 7 Install Disc, Block and Retainer 3 Remove Retainer, Block and Disc from Cylinder 8 Reinstall Cylinder as Shown NOTE: Make sure top of cylinder is pointing toward keypad. Keypad 4 Remove Cylinder Cap, Tailpiece, Pin,