Ives Offset Jamb Mount Top Pivot 7212V دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation Instructions
7212V 3/4” Offset Jamb Mount Top Pivot
3/32” Allen
wrench
Right hand
Set
installation
screw
shown; left
hand opposite
Door
Right hand Left hand
Jamb
leaf
installation
installation leaf
Pivot
pin
1. Prepare and mortise top of door and side jamb to receive pivot set. Determine pivot location
using dimensions on reverse side. The pivots are handed. To determine hand of door and
proper pivot position, see diagrams above.
2. Locate, drill, and tap 1/4-20 mounting holes for m

ملخص المحتوى في الصفحة رقم 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Heel edge of door must be beveled 1/8” in 2” as shown below. 5/8” 3/8” Jamb Leaf 16 mm 10 mm 1-1/8” 29 mm 5/16” 8 mm Face of door 9/16” 1” 14 mm 25 mm Edge of door 1-1/8” 29 mm Door Leaf 3/4” 19 mm 31582-00 31582 Rev. 4