Human Touch HT-135/136 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

06/01/08
REPLACING THE BACKREST ACTUATOR
HT-135/136
®
To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
SERVICE LEVEL: 3
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
Tools Required: Small Phillips-head screwdriver, short-handled Phillips-head screwdriver
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBL

ملخص المحتوى في الصفحة رقم 2

4. Lying on your back underneath the right-hand side of the chair, locate the backrest actuator (Fig.3). 5. Using a short-handled Phillips-head screwdriver, remove the five screws (and their washers) (Fig.3). NOTE: A short-handled screwdriver helps ensure that you can maintain a straight angle, so you do not strip the screws. 6. Remove the actuator from the chair base. The actuator Actuator cable (Fig.3) NOTE: View of actuator with chair upside-down. INSTALLING THE NEW ACTUATOR 1. Lying o