Metra Electronics 95-7323 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS FOR PART 95-7323
APPLICATIONS
Hyundai Entourage 2007-2008
Kia Sedona 2006-up
95-7323
KIT FEATURES
• Double DIN radio provision
• Stacked ISO units provision
KIT COMPONENTS
A) • Double DIN Trim Plate B) • Double DIN Brackets
A B
WIRING & ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
• 70-1004 Hyundai/Kia harness 2004-up
Antenna Adapter:
• Not Required
TOOLS REQUIRED
Panel Removal Tool • Phillips Screwdriver • Small Flat Blade Screwdriver
METRA. THE WORLD’

ملخص المحتوى في الصفحة رقم 2

95-7323 Table of Contents Dash Disassembly – Hyundai Entourage 2007-2008 – Kia Sedona 2006-up 3 Kit Assembly – Double DIN radio provision 4 – Stacked ISO units head provision 5 Caution Metra recommends disconnecting the negative battery terminal before beginning any installation. All accessories, switches, and especially air bag indicator lights must be plugged in before reconnecting the battery or cycling the ignition. *NOTE: Refer also to the instructions included with the aftermarket r

ملخص المحتوى في الصفحة رقم 3

95-7323 Dash Disassembly 1. Unclip and remove panel surrounding shifter. (Figure A) 2. Remove (2) Phillips screws at bottom corners of panel surrounding radio. (Figure B) 3. Unclip and remove entire panel surrounding radio including the clock and a/c vents. (Figure C) 4. Remove (4) Phillips screws securing radio. (Figure A) 5. Unplug and remove the radio. Continue to kit assembly (Figure B) (Figure C) 3

ملخص المحتوى في الصفحة رقم 4

Kit Assembly 95-7323 Double DIN radio provision 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 3. Slide the Double DIN radio into the bracket/trim plate assembly and secure (Figure A) the radio to the assembly using the screws su

ملخص المحتوى في الصفحة رقم 5

Kit Assembly 95-7323 Stacked ISO units head provision 1. Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation. 2. Snap the Double DIN brackets to the inside edge of the Double DIN trim plate. (Figure A) 3. Slide the stacked ISO units into the bracket/radio housing assembly and (Figure A) secure the units to the kit using the screw

ملخص المحتوى في الصفحة رقم 6

Notes

ملخص المحتوى في الصفحة رقم 7

Notes

ملخص المحتوى في الصفحة رقم 8

INSTALLATION INSTRUCTIONS FOR PART 95-7323 METRA. THE WORLD’S BEST KITS.™ metraonline.com 1-800-221-0932 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION REV. 5/17/11