ملخص المحتوى في الصفحة رقم 1
2
ملخص المحتوى في الصفحة رقم 2
USER’S MANUAL TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ------------------------------------- 3 PREPARATION ---------------------------------------------------------------------- 4 OPERATING INSTRUCTIONS -------------------------------------------------- 6 Use of the remote control --------------------------------------------------- 6 To use the menus ------------------------------------------------------------- 7 Main menu ------------------------------------------------
ملخص المحتوى في الصفحة رقم 3
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) tha
ملخص المحتوى في الصفحة رقم 4
16. This product may contain lead or mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org 17. Damage Requiring Service – The appliance should be serviced by qualified service personnel when: A. The power supply cord or the plug has been damaged; or B. Objects have fallen, or liquid has been spilled into the appliance; or C
ملخص المحتوى في الصفحة رقم 5
EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE Note to the CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Please, make sure to connect the power plug to the wall outlet socket after connect
ملخص المحتوى في الصفحة رقم 6
2. Insert the aerial plug firmly into the aerial socket at the back of the TV. 3. Remote control: Remove the cover of the battery compartment. Insert the 2 batteries supplied (Type AAA 1.5V). 4. Power: Insert the power cord in the wall socket having an AC power supply. 5. Turn the TV on: Turn the main power switch on the right side of TV to ON. Press the secondary power button in front of the TV to turn it on. If the main power switch is OFF, the front LED light
ملخص المحتوى في الصفحة رقم 7
OPERATING INSTRUCTIONS USE OF THE REMOTE CONTROL MUTE POWER Temporarily interrupt the Press to turn on/off the sound or restore it. TV. The TV is never completely powered off unless it is physically unplugged. DISPLAY Press this button to 0~9/100 Digit buttons Display Channel number To select a TV channel. on the right-top corner. CH Press or ( or ) to browse through the TV MTS /SAP channels,which are not Press this key to acti
ملخص المحتوى في الصفحة رقم 8
TO USE THE MENUS 1. Press 1. Press the the MENU MENU button to display button to display each menu each menu 2. 2. Use the cursor up/dow Use the cursor up/down n to select a menu item. to select a menu item. 3. 3. Use the cursor left/right to ent Use the cursor left/right to enter a submenu or enable/disable the er a submenu or enable/disable the function. function. 4. 4. Press the Press the MENU MENU button to exit the menu. button to exit the menu. MA MAIN
ملخص المحتوى في الصفحة رقم 9
OSD Setup 1. Set OSD language 2. Adjust the horizontal position of the OSD. 3. Adjust the vertical position of the OSD. 4. Adjust the OSD time-out. 5. OSD Background Adjustment 10
ملخص المحتوى في الصفحة رقم 10
TV Setup 1. AIR/CATV for different TV input solution, RF and cable. 2. Auto searching is used for searching all TV program channels. After finishing search and exiting, the machine will save the program automatically, you can also press “menu” to break the searching, but only the searched programs are saved when the machine exits searching. 3. Add/Erase is for add or delete the current channel for memorizes. 4. Current Program is display the current channel number。 5. Sleep Tim
ملخص المحتوى في الصفحة رقم 11
Text Mode:TT1~TT4 Often used for channel guide, schedules, bulletin board information for Closed Caption programs, news, weather information or stock marker reports. Not all Closed Caption modes are necessarily being use by a TV channel during the transmission of a Closed Caption program. V-CHIP Setup Select V-Chip on OSD then enter 4 digits of pin number. Initial pin number is “0000”. If you enter an incorrect pin number “Error” message will be displayed. It is the parental con
ملخص المحتوى في الصفحة رقم 12
C. Setting up Movie Guidelines Use Up/Down arrow buttons to move around the matrix and press Right arrow button to change the value from “U” to ‘B” or “B” to “U” 13
ملخص المحتوى في الصفحة رقم 13
D. CHANGE PIN Personal Identification Number is for change password to control the V-chip setup; it’s included three steps. ENTER PIN to enable this function, then ENTER NEW PIN to change a new one. After that COMFIRM NEW PIN. Picture Setup 1、 Contrast, Brightness and Saturation are adjusted from 0 to 100. 2、 Hue is adjusted from 0 to 100. 3、 Sharpness is adjusted from 0 to100. Hue is only adjusted in NTSC telecast system. You can adjust contrast, brightness, saturation, hue
ملخص المحتوى في الصفحة رقم 14
CONNECT PERIPHERAL EQUIPMENT FRONT PANEL CONTROL KNOBS Power Key⑦ : Press to turn on or off the TV. MENU Key⑥ : Press to show the OSD menu and exit OSD menu at the TV. Down / Up Key⑤④ : Press to perform select function and channel. + /- Key②③ :Press to confirm your function selection and adjustment. Source Key① : Press to select your input source. There is a wide range of video and audio equipment that can be connected to your TV. The following connection diag
ملخص المحتوى في الصفحة رقم 15
PREPARATION Remove the back plate at the back of the TV as shown on the illustration opposite. Lay the LCD TV with the screen down on a table, as it will be easier to connect your peripheral equipment. Please take precaution not to damage the screen. ①1: RF TV port 2: Earphone output port ② 3: Right audio input port ③ ④4: Left audio input port ⑤5: AV video port 6: S-VIDEO video port ⑥ 7: power input port ⑦ 16
ملخص المحتوى في الصفحة رقم 16
VIDEO RECORDER How to connect 1. Connect the supplied antenna cable to the RF IN port of your VCR. 2. Connect another RF cable ① from the output RF of your VCR to the Antenna input of your TV. Better quality when playing from your VCR can be obtained if you also connect the Video, Audio LEFT AND right (only for stereo equipment) cables ⑤ to the VIDEO, AUDIO L and R inputs AV. If your VCR has an S-VHS video jack: For improved picture quality, connect a S-Video cable with the
ملخص المحتوى في الصفحة رقم 17
DVD PLAYER Connect the video output port of DVD player to the video input port of TV. Connect the left and right audio of DVD to the left and right channels of audio input of TV. If your DVD player is equipped with S-VHS video port: For better quality picture, please connect the S-video cable to the S-video input port ⑥ of TV. Connecting the audio output ports ③④ through audio cable is a must since S-video input port is not attached with audio. How to play If you use conne
ملخص المحتوى في الصفحة رقم 18
TIPS Care of the screen Do not rub or strike the screen with anything hard as this may scratch, mar, or damage the screen permanently. Unplug the screen before cleaning the screen. Dust the TV by wiping the screen and the cabinet with a soft, clean cloth. If the screen requires additional cleaning, use a clean, damp cloth. Do not use liquid cleaners or aerosol cleaners. Mobile telephone warning To avoid disturbances in picture and sound, malfunctioning of your TV or even da
ملخص المحتوى في الصفحة رقم 19
Product Specification 20” screen Feature Items Specification Screen Size 20” screen Aspect Ratio 4 : 3 Display Area (opening) 408mmx306mm H x V Pixel Pitch 0.2125mm x 0.6375mm LCD Panel Display colors 16.7 million Lamp Type/Life 60000 hr Color Temperature Cool / Warm TV Standard NTSC M TV Function Sound systems MTS、SAP Colour systems NTSC DPF function Supported by memory Not supported (Optional) card Wireless FM transmission earphone Not supported frequ
ملخص المحتوى في الصفحة رقم 20
Speaker (built-in): Two 2 watt speakers Audio Output Audio Output: L / R Headphone Mini-jack for stereo (3.5ø) OSD English / French / Spanish/Portuguese language Table Stand Included Wall Mount VESA 100 x 100 mm Power Supply AC100V~240V, 50/60Hz Power Power Consumption <75W Forwards/Backwards/ Panel Tilt -4°/ +18° / ± 35° Rotation operating + 0 °C ~ + 40 °C storage Environment - 25 °C ~ + 60 °C operating 10% ~ 85% Dimension W x H x D (with stand) 498 x 489 x 256(mm) Weigh
