ملخص المحتوى في الصفحة رقم 1
ONBOARD BA ONBOARD BA ONBOARD BATTER TTER TTERY CHARGER Y CHARGER Y CHARGER
ONBOARD BA ONBOARD BATTER TTERY CHARGER Y CHARGER
1.5 AMPS 1.5 AMPS 1.5 AMPS
1.5 AMPS 1.5 AMPS
92426
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®
Copyright © 2004 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written
ملخص المحتوى في الصفحة رقم 2
Specifications Item Description Power Conversion 120 VAC to 12 VDC at 1.5 amps Power Plug Two-prong, non-polarized, 18 AWG x 2; Cord: 8” (L) Overall 4-7/8 (W) x 1-3/4 (D) x 3-1/2 (H) inches; Dimensions With mounting ears: 4-5/8 (H) inches Features Charge 12 VDC batteries without overcharging Automatic shut off Installs next to battery Weight 1.7 lbs. Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, par
ملخص المحتوى في الصفحة رقم 3
7. Do not expose power appliances to rain or wet conditions. Water entering a power appliance will increase the risk of electric shock. 8. Do not abuse the Power Cord. Never use the Power Cord to carry the appliance or pull the Plug from an outlet. Keep the Power Cord away from heat, oil, sharp edges, or moving parts. Replace damaged Power Cords immediately. Damaged Power Cords increase the risk of electric shock. 9. When operating a power appliance outside, use an outdoor extension cord marked
ملخص المحتوى في الصفحة رقم 4
21. Maintain appliances with care. Do not use a damaged Charger. Tag damaged products “Do not use” until repaired. 22. Check for damaged power cords or leads, breakage of parts, and any other condition that may affect the Charger’s operation. If damaged, have the product serviced before using. Service 24. Service must be performed only by qualified service technician. Service or maintenance performed by unqualified personnel could result in a risk of injury. 25. When servicing this product,
ملخص المحتوى في الصفحة رقم 5
10. Do not allow the Black and Red battery cables or terminals to touch. Failure to adhere to these directions could result in severe personal injury. If this happens, sparks will occur that can melt connection lugs, or other metal objects, and create the potential for fire. 11. Use only with vehicles and boats with 12 volt electrical systems. 12. Remove the keys from the vehicle. 13. Keep extension cord off the ground and away from water when recharging the unit. 14. Always connect the Line Co
ملخص المحتوى في الصفحة رقم 6
3. Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure A.) DOUBLE INSULATED TOOLS: TOOLS WITH TWO PRONG PLUGS 4. Tools marked “Double Insulated” do not require grounding. They have a special Figure B double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc
ملخص المحتوى في الصفحة رقم 7
Figure C Recommended Mimimum Wire Gauge for 120 Volt Extension Cords* Nameplate Amperes (At Extension Cord Length Full Load) 25 Feet 50 Feet 75 Feet 100 Feet 150 Feet 18 18 18 18 16 0 - 2.0 18 18 18 16 14 2.1 - 3.4 3.5 - 5.0 18 18 16 14 12 6.1 - 7.0 18 16 14 12 12 16 14 12 10 X 7.1 - 12.0 14 12 10 X X 12.1 - 16.0 16.1 - 20.0 12 10 X X X SYMBOLOGY Double Insulated Canadian Standards Association Underwriters Laboratories, Inc. Volts Alternating Current V ~ Amperes A ne o load xxxx per min. No Loa
ملخص المحتوى في الصفحة رقم 8
Battery Charger 8. Do not throw the battery in a fire or in the general trash. Contact your local hazardous waste disposal authority for proper disposal. 9. Do not drain the battery completely before recharging. Recharge fully. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this produ
ملخص المحتوى في الصفحة رقم 9
Replace the nut and securely tighten. Slide the red cover back over the positive terminal. 7. Unscrew the negative (–) terminal nut and place the black wire (lug) from the Battery Charger over the (–) terminal screw. Replace the nut and securely tighten. Operation Caution: Do not attempt to start the vehicle engine with Battery Charger connected to an extension cord and powered up. If the battery is damaged, or is low on battery fluid, do not attempt to charge it. Caution: The Onboard Battery C
