Master Lock Datsen Back-up Camera 4843 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

4843DATSEN Back-Up Camera Instructions
Hardware and Components Included:
Wireless Antenna (1) Power Cable (1) Vent Clip (1)
Monitor (1)
Flexible Mounting Arm
w/ Suction Cup Base (1)
Camera with
Guide/Hood (1)
Mounting the Camera:
The camera has two basic mounting options:
Antenna
Figure 1
1. The camera (figure 1) can be mounted inside a 1 ¼” (figure 2) or 2” (figure 3)
hitch receiver tube. Slide the camera assembly into the hitch tube. The magnet
in the camera base will hold it securely i

ملخص المحتوى في الصفحة رقم 2

Connecting the Monitor and Antenna: Figure 6 ATTACHING THE ANTENNA The wireless antenna (figure 6) attaches to the threaded connector on the back of the monitor (figure 7). Once attached, it can be rotated 360° as needed to find the position which give the best reception from the camera. Figure 7 Mounting Slot MOUNTING THE MONITOR Threaded Wireless Antenna Connector When choosing a location to mount the monitor (figure 7), make sure the monitor is in an area that will not obstruct your vi

ملخص المحتوى في الصفحة رقم 3

Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. IMPORTANT SAFETY INSTRUCTIONS PLEASE READ THIS OWNER’S MANUAL CARE