ملخص المحتوى في الصفحة رقم 1
PN-T321
LCD MONITOR
OPERATION MANUAL
ملخص المحتوى في الصفحة رقم 2
IMPORTANT: To aid reporting in case of loss or theft, please record the Model No.: product’s model and serial numbers in the space provided. The numbers are located in the rear of the product. Serial No.: U.S.A. ONLY
ملخص المحتوى في الصفحة رقم 3
IMPORTANT INFORMATION WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the CAUTION user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may RISK OF ELECTRIC be of sufficient magnitude to constitute a risk of SHOCK electric shock to persons. DO NOT OPEN The exclamation point within a triangle is intende
ملخص المحتوى في الصفحة رقم 4
DEAR SHARP CUSTOMER Thank you for your purchase of a SHARP LCD product. To ensure safety and many years of trouble-free operation of your product, please read the Safety Precautions carefully before using this product. SAFETY PRECAUTIONS Electricity is used to perform many useful functions, but it can also cause personal injuries and property damage if improperly handled. This product has been engineered and manufactured with the highest priority on safety. However, improper use can result in
ملخص المحتوى في الصفحة رقم 5
SAFETY PRECAUTIONS (Continued) 19. Batteries — Incorrect use of batteries may cause the batteries to burst or ignite. A leaky battery may corrode the equipment, dirty your hands or spoil your clothing. In order to avoid these problems, make sure to observe the precautions below: • Install the batteries with due attention to the plus (+) and minus (-) sides of the batteries according to the instructions in the compartment. • Replace an exhausted battery with a new one promptly. • Do no
ملخص المحتوى في الصفحة رقم 6
TIPS AND SAFETY INSTRUCTIONS - The TFT color LCD panel used in this monitor is made with Manual Scope the application of high precision technology. However, there - Microsoft, Windows, Windows Vista, PowerPoint and Internet may be minute points on the screen where pixels never light Explorer are registered trademarks of Microsoft Corporation. or are permanently lit. Also, if the screen is viewed from - HDMI, the HDMI Logo and High-Definition Multimedia an acute angle there may be uneven
ملخص المحتوى في الصفحة رقم 7
MOUNTING PRECAUTIONS • This product is for use indoors. • After mounting, please carefully ensure the monitor is • Consult your dealer before installing, removing or moving secure, and not able to come loose from the wall or mount. the monitor. • Do not place the monitor on a device which generates heat. • A mounting bracket compliant with VESA specifications • Use the supplied vertical sticker when you install the is required. Do not use any screw holes other than VESA monitor in vertical ori
ملخص المحتوى في الصفحة رقم 8
Contents IMPORTANT INFORMATION ............................................1 Basic Operation .............................................................14 DEAR SHARP CUSTOMER ..............................................2 Auto playback of image and audio files (Slideshow) ..16 SAFETY PRECAUTIONS....... ...........................................2 Menu Items .....................................................................17 TIPS AND SAFETY INSTRUCTIONS ...............................4 Dis
ملخص المحتوى في الصفحة رقم 9
Part Names nFront view 1. LCD panel 2. Power LED (See page 13.) 3. Power switch (See page 13.) 4. Input switch (See page 14.) 5. Remote control sensor (See page 12.) 1 TIPS • Use a pointed object such as a pen tip to press the switches at the operation panel. 234 5 Rear view n 1. Speakers 2. USB flash drive cover 3. Vents 3 2 4. Main power switch (See page 13.) 5. AC input terminal (See page 10.) 6. USB port (See page 9.) 7. RS-232C input terminal (See page 9.) 8. Audio output termi
ملخص المحتوى في الصفحة رقم 10
Part Names nRemote control unit 1. Signal transmitter 1 2. POWER button (See page 13.) 3. MUTE button (See page 14.) 4. VOL +/- buttons (See page 14.) BRIGHT +/- buttons (See page 14.) 2 7 Cursor control ( / / / ) buttons 5. DISPLAY button (See page 14.) 3 8 6. MODE button (See page 14.) 7. INPUT button (See page 14.) 4 8. MENU button (See page 14.) 9. SIZE button (See page 14.) 9 5 6 E 8
ملخص المحتوى في الصفحة رقم 11
Connecting Peripheral Equipment 1 2 3 4 5 6 7 8 3. AV video/AV audio input terminal Caution • Connect with the provided conversion cable (for AV • Be sure to turn off the main power switch and disconnect video), and then connect the end to a commercially the plug from the power outlet before connecting/ available video / audio cable (RCA). disconnecting cables. Also, read the manual of the equipment to be connected. 4. AV COMPONENT input terminal • Be careful not to confuse the input termin
ملخص المحتوى في الصفحة رقم 12
Connecting the Power Cord Caution • Do not use a power cord other than the one supplied with the monitor. 1. Turn off the main power switch. 2. Plug the power cord (supplied) into the AC input terminal. 3. Plug the power cord (supplied) into the AC power outlet. 3 Main power switch For power 1 outlet 2 Power cord (Supplied) AC input terminal TIPS • Insert the power code through the claw at the bottom of the monitor (left side of the monitor if oriented vertically). For the monitor in horizonta
ملخص المحتوى في الصفحة رقم 13
Binding Cables The cables connected to the terminals on the rear of the monitor can be fastened with the cable clamp. Attach the cable clamp to the back of the monitor, and fasten the cables. Cable Cable clamp Setting the USB flash drive cover 1. Insert the USB flash drive into the USB port. 2. Attach the USB flash drive cover and secure with the provided screw. Insert the claw (1) into the monitor, and while pressing in the direction of (2), insert the claw (3) into the monitor. (3) USB p
ملخص المحتوى في الصفحة رقم 14
Preparing the Remote Control Unit Batteries and an insulation sheet are preinstalled in the Remote control operation range remote control at the factory. Before using the remote control, be sure to remove the insulation sheet. The operation range of the remote control unit is approx. 16.4 feet (5 m) at an angle of approx 10° from the center to the top/ bottom/right/left of the remote control sensor. Insulation sheet Pull out Remote control Changing the battery sensor 1. Pull out the battery
ملخص المحتوى في الصفحة رقم 15
Turning Power On/Off Caution Turning power on/off • Turn on the monitor first before turning on the PC or Press the POWER button or POWER switch to turn the power playback device. ON/OFF. When the main power is off, the power cannot be turned on with the POWER button. Turning on the main power Main power switch Power LED • Status of the power LED Status Status of the monitor Green lit Power on Caution Orange lit Power off (Standby mode) • The main power must be turned on/off with the main pow
ملخص المحتوى في الصفحة رقم 16
Basic Operation 3. MENU 1 Displays and turns off the menu screen (see page 18). 2 3 4. VOL +/- (Volume adjustment) Pressing or displays the VOLUME menu when the 4 menu screen is not displayed. VOLUME 15 5 Press or to adjust the volume of the sound. * If you do not press any buttons for about 4 seconds, the VOLUME menu automatically disappears. 5. BRIGHT +/- (Backlight adjustment) Pressing or displays the BRIGHT menu when the menu screen is not displayed. 6 7 BRIGHT 15 8 Press or to adjust the
ملخص المحتوى في الصفحة رقم 17
Basic Operation nSwitching the screen size Even when the screen size is changed, the display may remain the same depending on the input signal. WIDE Displays image so it fills the entire screen. ZOOM 1 An image with a 4:3 aspect ratio is enlarged to fill the entire screen without changing the aspect ratio. The edges of the image may be cut off. ZOOM 2 Use this size if ZOOM 1 cuts off the subtitles. NORMAL Displays image so it fills the screen without changing the aspect ratio of the input sign
ملخص المحتوى في الصفحة رقم 18
Basic Operation Auto playback of image and audio files (Slideshow) When the input mode is set to USB and a USB flash drive is inserted in the USB port, the image files in the root folder of the USB flash drive will be automatically displayed as a slideshow. If there is an audio file in the root folder, the audio file will also automatically play. If you want to present a slideshow in a different folder, see page 19. TIPS • Playback will also start automatically if you change from an input term
ملخص المحتوى في الصفحة رقم 19
Menu Items TIPS Displaying the menu screen • The menu will differ depending on the input mode. Video and audio adjustment and settings of various functions • The menu screen will close automatically if no operation is are enabled. This section describes how to use the menu performed for about 15 seconds. items. See pages 18 to 19 for details of each menu items. Menu screen display n Caution 13 2 • Do not turn the main power switch off while the menu items are being displayed. Doing so may i
ملخص المحتوى في الصفحة رقم 20
Menu Items nPICTURE Menu item details CONTRAST The menu will differ depending on the input mode. Adjusts the brightness of the image. nSCREEN (D-SUB input) BLACK LEVEL AUTO Adjusts the entire brightness of the video signals. TINT (AV signal input) The CLOCK, PHASE, H-POS, and V-POS are automatically adjusted. Adjusts the hue. Selecting + changes the color towards Pressing performs adjustment. green, and selecting - changes it towards magenta. Use this automatic adjustment when you use the PC
