Havis-Shields C-VS-0309-F250 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

4
INSTALL INSTRUCTIONS C-VS-0309-F250
VEHICLE SPECIFIC CONSOLE
1999-2007 FORD F-250, 350, 450, 550


TOOLS REQUIRED:
Ratcheting wrench Screwdriver set
Sockets Set T-20 torx bit
Cutting tool (if necessary)

HARDWARE:
QTY DESCRIPTION PART #
2 ¼” x 1 ¼” Hex head bolt GSM33003
2 ¼” Flat washer GSM31005
2 ¼” Serrated nut GSM30023
4 #8 x ¼” Phillips flat head sheet metal GSM33178
1 Torx Screw kit C-HK-1

Always!

Read all instructions before installing any Havis-Shields Equipmen

ملخص المحتوى في الصفحة رقم 2

Remove upper portion of Remove enough to expose hex View of Ford F-Series dashboard screws holding lower portion of dashboard as shown above dashboard Remove (2) upper hex screws Remove (2) screws as shown Remove plastic trim piece as located under the upper portion of above shown above the trim. C-VS-0309-F250_INST_4-07 2

ملخص المحتوى في الصفحة رقم 3

Remove (2) screws on lower side Remove two hex screws on each Remove (2) hex screw as shown of lower trim panel. The insert side of cup holder bracket above. Notice location. this screw attaches to will be removed. See later instruction. Remove plugs on optional brake Remove brake control switch from Remove lower trim panel lower trim panel. This will reinstall control switch. (If necessary) into console. (Equipment bracket sold separately) Current view of installation Remove opt

ملخص المحتوى في الصفحة رقم 4

Remove this screw clip to allow a Attach lower portion of console ¼” bolt to fit into this hole using ¼” x 1 ¼” hex bolt, washer and serrated nut Complete installation of C-VS-0309-F250 console Complete installation of C-VS-0309-F250 console w/ accessories (Sold separately) -Brake controller/Aux Switching equipment bracket (C-EB30-F50-1P) -Mic Clip Bracket (C-MCB w/ C-MC) -Cup holder (C-CUP2-E-C with additional “L” bracket # CM93086 ) C-VS-0309-F250_INST_4-07 4