Peripheral Electronics دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

PESWIPS
Power
11-29-05
PESWIPS
Troubleshooting Guide
Universal Steering Wheel Control Interface
No power / won’t go into programming mode:
For Pioneer and Sony Radios
• Check Red wire connection and fuse. Make sure INTERFACE is connected to switched +12volts, not constant +12volts.
with wired remote inputs. Installation Instructions
• Make sure vehicle ignition is on.
The INTERFACE controls the stereo immediately without pressing any buttons on the steering wheel:
• During programming, press

ملخص المحتوى في الصفحة رقم 2

11-29-05 Wiring Connections Appendix A: Known Incompatible Vehicles Note: Only 3 wires will be used during installation. Only GM vehicles programmed for version #4, will use 4 wires. Vehicle Make(s) Year(s) Model(s) Step 1. Step 2. BMW All All with factory-activated cellular phones Connect the BLACK Connect the RED wire All with 5-volt SWC data wire at the steering column wire to ground (-). to switched +12V. 2002-2003 5-Series w/navigation Mercedes-Benz All All vehicles Verifi cation: Wire Ver

ملخص المحتوى في الصفحة رقم 3

PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS 11-29-05 Programming the PESWIPS to Work With the Vehicle Testing the PESWIPS Step 5. Note: For Sony head units, please refer to the note below. Refer to The Vehicle Appication Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information below for quick reference. Test each Heater function of the steering wheel controls. The VOL TEMP and FAN should work properly. When testing the audio TEMP controls, the

ملخص المحتوى في الصفحة رقم 4

PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS PESWIPS 11-29-05 Programming the PESWIPS to Control the Head Unit Programming the PESWIPS to Control the Head Unit (cont.) IMPORTANT! Some steps of the programming instructions must be completed within a certain number of seconds following the The PESWIPS must be programmed in the specifi c order shown below. If a function is not needed, it may be skipped. previous step. Review