American Standard FloWise Dual Flush 2-Piece Toilet 2484.216 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
FloWise™ DUAL FLUSH 2-PIECE TOILET
Model 2479.216 / 2479.516 / 2476.216 / 2476.516 / 2779.516
Model 2480.216 / 2480.516 / 2484.216 / 2484.516 / 2778.516 /
Certified by
IAPMO R&T
2566.216 Right Height™
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require profes

ملخص المحتوى في الصفحة رقم 2

6 7 Tank Installation Kit Includes: 2 bolts, 2 rubber washers, 4 metal washers, 4 metal nuts, 2 plastic nuts, 1 large rubber gasket. RUBBER WASHER RUBBER TANK MTG. GASKET BOLTS BOLT CAP WASHER NUT CLOSET FLANGE WASHER NUT CLOSET BOLT INSTALL TANK WASHER NUT a. Discard plastic nuts. b. Install tank mounting bolts and rubber INSTALL TOILET washers from inside tank, through mounting holes and secure with one a. Position toilet squarely to wall and, with a rocking metal washer and one nut pe

ملخص المحتوى في الصفحة رقم 3

10 11 ADJUSTMENTS PUSH BUTTON a. Adjust water level. Water level should be adjusted to level indicated on tank by ARM TOP NIPPLE adjusting float cup. See Step 11 for water level CRITICAL adjustment method. LEVEL MARK ("C.L.") MUST b. Make sure Full Flush Adjustment is at BE 1" ABOVE SET WATER OVERFLOW FLUSH the bottom setting (0). A higher setting LEVEL HERE PIPE VALVE FLOAT will result in less water and is not CUP recommended. PARTIAL FILL FLUSH

ملخص المحتوى في الصفحة رقم 4

TROUBLESHOOTING 14 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: LIFT ARM FIRST • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper). IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL OF TANK WATER IS SLOW after valve has been in use for some time, Fluidmaster Model 242 Replacement Seal may be