American Standard Right Height Elongated Toilet with 12" Rough Tank and Seat 3305 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
Model 3305 Right Height™ Elongated Toilet
with 12” Rough Tank and Seat
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. (Certain installations
may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND P

ملخص المحتوى في الصفحة رقم 2

6 7 For Tanks/Bowls using Speed Connect System (Tank mounting bolts pre-installed). RUBBER TANK MTG. GASKET BOLTS PRE- INSTALLED BOLT CAP CLOSET FLANGE WASHER/ NUT COMBO CLOSET BOLT INSTALL TANK WASHER NUT a. Install large rubber gasket over threaded outlet on bottom of tank and INSTALL TOILET lower tank onto bowl so that tapered end of gasket fits evenly into bowl a. Position toilet squarely to wall and, with a rocking water inlet opening, and tank mounting motion, press bowl down f

ملخص المحتوى في الصفحة رقم 3

10 11 TOP ARM REFILL NIPPLE TUBE ADJUSTMENTS a. Adjust water level. Water level TANK LEVER CRITICAL LEVEL should be adjusted to level indicated MARK ("C.L.") Fig. 10A MUST BE on tank by adjusting float cup. 1" ABOVE "S" OVERFLOW PIPE FLOAT CLIP CUP See Step 11 for water level adjustment method FLUSH FILL VALVE VALVE b. If bowl fails to siphon, an adjustment may be required with the lift chain. VALVE BODY WATER LEVEL Simply remove the bead chain from ADJUSTMENT ROD the retai

ملخص المحتوى في الصفحة رقم 4

TROUBLESHOOTING 13 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below water level in tank. Attach refill tube to overflow pipe LIFT ARM using "S" clip provided. FIRST • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper). IF FILL VALV