American Standard TownSquare Pressure Balancing Bath and Shower 2555.652 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Installation
Instructions
TOWNSQUARE
2555.652
PRESSURE BALANCING BATH AND
SHOWER with Built-in Diverter for
RIM MOUNT TUB FILLER
with EverClean™ Finish
Congratulations on purchasing your American Standard faucet with
EverClean finish found only on American Standard faucets.
EverClean Finish
• One wipe effortlessly removes spots
 Eliminates the need for cleaners and scrubbing
Certified to comply with ANSI A112.18.1
 Permanent surface protectant remains beautiful
for the life of the fauc

ملخص المحتوى في الصفحة رقم 2

INSTALL DIVERTER 2 DIVERTER PORT When finished tiling the wall, remove PLASTER GUARD (1). Remove two screws that secure the DIVERTER LID (2) and remove Lid. Inspect the inside surface of diverter port. 2 Diverter port must be free of any dirt. Clean if necessary. Install DIVERTER (3) with SCREWS (4) removed with DIVERTER LID (2). Operate DIVERTER (3). DIVERTER (3) should slide in and out smoothly. Push on DIVERTER COVER (5). 3 4 5 1 INSTALL TRIM 3 Push CAP (1) over VALVE CARTRIDGE (2). Mount ESC

ملخص المحتوى في الصفحة رقم 3

7 5 3 1 1 1 5 5 0 1 1 3 3 1 1 1 1 9 9 7 7 5 5 3 3 1 1 ADJUST HOT LIMIT STOP INSTALL HANDLE AND DIVERTER KNOB 4 5 Install HANDLE BUSHING (1) onto CAP (2). By restricting HANDLE rotation and limiting the amount of hot Find correct position of HANDLE (3) and push water allowed to mix with the cold, the HOT LIMIT SAFETY HANDLE (3) onto VALVE STEM (4). STOP (1) reduces risk of accidental scalding. To set the maximum Install HANDLE SCREW (5) and push in INDEX CAP (6). hot water temperature of your fa