Auralex Acoustics ELiTE ProPanel Panels دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

™ ™
ELiTE ProPanel
Installation Guide
Auralex Acoustics, Inc. ◆ 800-959-3343 ◆ Fax: 317-842-2760

ملخص المحتوى في الصفحة رقم 2

™ ™ ELiTE ProPanel Installation Guide Impaling Clips Figure 1.2 Figure 1.1 Impaling Clip placement Impaling Clip installation on 4’x8’ panel side view Figure 1.3 Impaling Clip detail Auralex Acoustics, Inc. ◆ 800-959-3343 ◆ Fax: 317-842-2760

ملخص المحتوى في الصفحة رقم 3

Impaling Clips General guidelines for all panels: 1. Whenever moving panels, transport them with the shortest dimension in the vertical position to reduce potential stress or breaking of the fiberglass. Do not move panels parallel to the floor without additional support. 2. If light colored fabrics are used, it may be a good idea to wear white cotton gloves so dirt, grease or grime from the skin is not transferred to the fabric. 3. Lay out panels with a laser level (preferred), hand level or c

ملخص المحتوى في الصفحة رقم 4

™ ™ ELiTE ProPanel Installation Guide Adhesives Figure 2.1 Adhesive installation side view Figure 2.2 Adhesive placement on 4’x8’ panel Auralex Acoustics, Inc. ◆ 800-959-3343 ◆ Fax: 317-842-2760

ملخص المحتوى في الصفحة رقم 5

Adhesives General guidelines for all panels: 1. Whenever moving panels, transport them with the shortest dimension in the vertical position to reduce potential stress or breaking of the fiberglass. Do not move panels parallel to the floor without additional support. 2. If light colored fabrics are used, it may be a good idea to wear white cotton gloves so dirt, grease or grime from the skin is not transferred to the fabric. 3. Lay out panels with a laser level (preferred), hand level or chalk

ملخص المحتوى في الصفحة رقم 6

™ ™ ELiTE ProPanel Installation Guide Z-Clips Figure 3.2 Z-Clip placement on 4’x8’ panel Figure 3.1 Z-Clip installation side view Figure 3.3 Wall Z-Clip detail Figure 3.4 Impaling Z-Clip detail Auralex Acoustics, Inc. ◆ 800-959-3343 ◆ Fax: 317-842-2760

ملخص المحتوى في الصفحة رقم 7

Z-Clips General guidelines for all panels: 1. Whenever moving panels, transport them with the shortest dimension in the vertical position to reduce potential stress or breaking of the fiberglass. Do not move panels parallel to the floor without additional support. 2. If light colored fabrics are used, it may be a good idea to wear white cotton gloves so dirt, grease or grime from the skin is not transferred to the fabric. 3. Lay out panels with a laser level (preferred), hand level or chalk li

ملخص المحتوى في الصفحة رقم 8

General Modifications Cut outs for electrical outlets/boxes: 1. Mark the intended location of each panel on the wall. 2. Carefully measure the exact location and size of the cut-out in the panel. An uninstalled identical unit may be used as a template for the cut-out. 3. Remove ONLY the fiberglass using a sharp knife making sure not to cut through the fabric on the other side. 4. Cut an X in the fabric directly over the cut-out. 5. Reapply the fabric to the fiberglass using a very light appl