ملخص المحتوى في الصفحة رقم 1
INSTALLATION INSTRUCTIONS
Instrucciones de instalación Istruzioni di installazione
Installationsanleitung Installatie-instructies
Instruções de Instalação Instructions d´installation
Automated Quad Horizontal Door System
This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This
ملخص المحتوى في الصفحة رقم 2
CM6QH SERIES Installation Instructions CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However, CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice or obligation of any ki
ملخص المحتوى في الصفحة رقم 3
Installation Instructions CM6QH SERIES System Features and Installation Requirements Features Remote Control Activated Lutron Light Dimmer Module With this dimmer cabinet lighting can be switched on or off and dimmed using the left buttons on the hand held remote control transmitter. Obstruction Sensor The system is equipped with a obstruction sensor. In the event that something would interfere the motion of the doors; the doors stop, reverse, run a few seconds, and then stop again. Auxiliary Co
ملخص المحتوى في الصفحة رقم 4
CM6QH SERIES Installation Instructions plate wheel into the track area built into the base. Then tip INSTALLATION the top of the door into the mechanism and engage the pendant bolts into the slots in the carriages. After hanging Installation the doors spin the locking nut on the pendant bolts up so 1. Secure track to top of cabinet. that the nut is finger tight against the bottom of the carriage. (See figure 3) 2. Align centerline on track with center of cabinet opening, and keep the front of th
ملخص المحتوى في الصفحة رقم 5
Installation Instructions CM6QH SERIES Figure 2 5
ملخص المحتوى في الصفحة رقم 6
CM6QH SERIES Installation Instructions Figure 3 Figure 4 6
ملخص المحتوى في الصفحة رقم 7
Installation Instructions CM6QH SERIES 1. Plug 115VAC lighting into the back of the Light Dimmer Install Valance Clips Module. Three Valance clips are supplied to assist in hanging a valance 2. Plug the other end of Dimmer Module cord into a 115VAC in front of the track. (See Figure 5). grounded receptacle on motor assembly. CAUTION: The Dimmer is for 120 volt incandescent or Halogen lamps of at least 25 watts and should not to exceed 300 watts total. The system also provides the option of creat
ملخص المحتوى في الصفحة رقم 8
CM6QH SERIES Installation Instructions 2. Plug Powercord into 115VAC outlet. box for approxamatly 13 seconds and then release it when the Status Light flashes quickly red, green, red, green, red, green. IMPORTANT ! : A quality surge protection device is recommended. Activator Button 3. Make sure nothing is obstructing movement of doors, 4. Press and release the Activator Button on the front of the Motor Box or the "Close Door button on the Remote Control. (The doors should travel to the fully cl
ملخص المحتوى في الصفحة رقم 9
Installation Instructions CM6QH SERIES track, or is the motor box bent, causing it to become uncoupled from the track? Control Input Power Loss - The Status Light will be on solid red. ---- There has been a power loss (due to an electrical storm, etc.). When next activated the doors will move at a slow speed to their full closed position. If the doors are already closed they will not move. The Status Light will return to solid green and the doors are ready for normal activation. Optional Con
ملخص المحتوى في الصفحة رقم 10
CM6QH SERIES Installation Instructions USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands P +31 (0)40 2668620 F +31 (0)40 2668615 Asia Pacific A Room 30I, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA. Post Code: 518112 8820-000021 2007 Chief Manufacturing www.chiefmfg.com P +86-755-8996 9226 ; 8996 9236 ; 8996 9220 03/07 F +86-755-8
