Cooper Lighting SA6150-SA6151 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

TM
Epic/Wall Mounted
Fixtures
Sheet 1 of 4
INSTALLATION INSTRUCTIONS
10/18/05 IMI-658
IMPORTANT: Read carefully before installing fixture. Retain for future reference.
General: Upon receipt of fixture thoroughly inspect for any Safety: This fixture must be wired in accordance with
freight damage, which should be brought to the attention of the national electrical code and applicable local codes
the delivery carrier. Compare the catalog description listed and ordinance. Proper grounding

ملخص المحتوى في الصفحة رقم 2

TM Epic/Wall Mounted Fixtures Sheet 2 of 4 INSTALLATION INSTRUCTIONS 10/18/05 IMI-658 IMPORTANT: Read carefully before installing fixture. Retain for future reference. FIXTURE MAINTENANCE A. Relamping Classical Top Horizontally lamped 1. Loosen two door screws. 2. Lower door to tethered resting position. See Figure 4. 3. Install suitable lamp. Consult re-lamp label and lamp instructions for details. Do not overtighten. Aligning Socket 4. Raise door and secure with screws. Aligning Pin V

ملخص المحتوى في الصفحة رقم 3

TM Epic/Wall Mounted Fixtures Sheet 3 of 4 INSTALLATION INSTRUCTIONS 10/18/05 IMI-658 IMPORTANT: Read carefully before installing fixture. Retain for future reference. WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing. Vertically lamped 1. Loosen and remove ring retaining screws globe retaining ring Fig. 4b Options and globe. Components are not tethered. Flat Lens or Sag Lens See Figure 5. 2. Remove two screws on ballast cover fo

ملخص المحتوى في الصفحة رقم 4

TM Epic/Wall Mounted Fixtures Sheet 4 of 4 INSTALLATION INSTRUCTIONS 10/18/05 IMI-658 IMPORTANT: Read carefully before installing fixture. Retain for future reference. WARNING: Risk of Electric Shock. Disconnect power at fuse or circuit breaker before installing or servicing. Vertically lamped 1. Loosen and remove ring retaining screws globe retaining ring and globe. Components are not tethered. See Figure 5. Ballast Cover Screws 2. Remove two screws on ballast cover followed by ballast