Elation Professional دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Technical Specifications:
Model: Waterfall™
Lamp: SC150 120v/150w HTI
Voltage: 110~120v
Dimensions: 10”H x 12”W x 15”L
Colors 6 plus White
Weight: 24 Lbs
Fuse: 5 Amp
User Instructions
©Elation Lighting
Elation World Headquarters:
Elation Lighting
4295 Charter Street Los Angeles, CA 90058 USA
4295 Charter Street
Tel: 323-582-2650 / Fax: 323-582-3108
Los Angeles Ca. 90058
Web: www.elationlighting.com / E-mail: info@elationlighting.com
www.elationlighting.com

ملخص المحتوى في الصفحة رقم 2

Waterfall™ Unpacking Waterfall™ Lamp Replacement Every Waterfall™ has been thoroughly tested and has been shipped Caution! Never open the unit when in use. Always disconnect the in perfect operating condition. Carefully check the shipping carton for main power before attempting to replace the lamp. Remember always damage that may have occurred during shipping. If the carton appears replace with the same type lamp and fuse. to be damaged, carefully inspect your fixture for any damage and

ملخص المحتوى في الصفحة رقم 3

Waterfall™ Dip Switch Settings Waterfall™ Set Up Power Supply: Before plugging your unit in be sure the source volt- MASTER - HEAD 1 HEAD 3 age in your area matches the required voltage for your Elation® Water- ™ fall.™ The Elation® Waterfall is available in a 115v and 230v version. ON ON Line voltage may vary from venue to venue. Be sure to plug your unit 10 7 8 9 10 7 8 9 1 2 3 4 5 6 1 2 3 4 5 6 into a matching wall outlet before attempting to operate. Data Cable (DMX Cable) Requirements (

ملخص المحتوى في الصفحة رقم 4

REMOTE REMOTE REMOTE INPUT OUTPUT INPUT OUTPUT INPUT OUTPUT SOUND CONTROL SOUND CONTROL SOUND CONTROL INPUT INPUT INPUT Waterfall™ Set Up Waterfall™ Operation POWER POWER POWER Stand Alone: This function is used when using only one unit or Special Note: Line Termination. When longer runs of cable are running more than one unit as individual fixtures. used, you may need to use a terminator on the last unit to avoid erratic DMX512 A. Set dip switch 10 to the on position (see page 6). be