Lightolier IS:1055LV دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

/
INSTRUCTIONSHEETNO.
INSTALLATION PROCEDURE FOR LOW VOLTAGE
REFLECTOR TRIM IN THE 1000LV FRAME-IN KIT
lS:1055LV
0s90 Page 1 of 2
READ AND UNDERSTAND THESE lNSTRU~lONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local regulation.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electrical shock, turn off electricity at fuse box before

ملخص المحتوى في الصفحة رقم 2

IS1055LV 0890 Page 2 of 2 LAMPING INSTRUCTIONS AND ADJUSTMENTILOCKING INSTALL LAMP 5. Remove LAMP RING from LAMPIYOKE HOLDER by pulling straight down (Fig. H). /. insert LAMP (MR-16) between LAMP SPRINGS until 6. face of LAMP sits firmly on GLASS LAMP GUARD (Fig, l). - ==77=. 7. Attach SOCKET to hi-in prongs on LAMP (Fig. l). fs~ LAMP s. Insert LAMP RING with LAMP and GLASS LAMP SPRING c GUARD attached back into LAMP/YOKE HOLDER (Fig. J). I-44: GL4S&5L~MP FIG. H WARNING: LAMP MANUFACTURERS REQUI