SmartPool Inc Underwater Lighting System NL50 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 1
NL50 INSTALLATION/OPERATION MANUAL
DO NOT PLUG LIGHT IN UNTIL INSTRUCTED IN MANUAL
READ ALL DIRECTIONS FIRST THEN REFER TO EXAMPLE IMAGES BEFORE PERFORMING THAT STEP
A. To install bulb, place the light on a table or similar flat, dry working surface.
Use the supplied seal ring lock key to loosen the seal ring. Insert the key into
the locking latch on the bottom of the light as shown in FIG 1. Turn and hold
the key to the left to release the lo

ملخص المحتوى في الصفحة رقم 2

2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 2 B. Use a Phillips head screwdriver to remove the three screws retaining the heat diffuser/heat shield. (See Fig 3) Place the screws in an area where they will not be lost. Carefully re- move the round diffuser/heat shield. C. Remove one of the three colored bulbs from its box being careful not to touch the face of the bulb. Place the legs of the bulb into one of the three ceramic outlets as shown in Figure 3. Repeat for the other two bulbs. NO

ملخص المحتوى في الصفحة رقم 3

2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 3 INSTALLATION A. Remove top cap of pool vertical post nearest your installation. B. Lift one end of your poolʼs top ledge. The top ledge is comprised of flat sections that extend around the top of the pool wall. C. Slide the pool light onto the pool wall submerging the light in the water. Locate the light in the middle of the top rail to allow for easier installation. D. Hold the light down so that the top of the mounting bracket is flush with

ملخص المحتوى في الصفحة رقم 4

2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 4 WINTERIZATION IMPORTANT: FAILURE TO PROPERLY WINTERIZE YOUR LIGHT WILL RESULT IN TERMINATION OF WARRANTY. Begin by unplugging the power cord from its power source. Using the included seal lock key, use the hex key side as shown in Fig 6. Insert tool into bolt head and turn counter clockwise until it is completely loose. Then pull the bolt com- pletely out and place in a safe place. Do the same for the other screw. Grasp the light body with one