American Standard Lakeland SERIES 7193 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

™ ®
AMERICAST BRAND
Installation
SELF RIMMING
Instructions
LAKELAND™ KITCHEN SINKS
SERIES 7193
Thank you for selecting American-Standard...the benchmark of fine quality
for over 100 years. To ensure that your installation proceeds smoothly--
Certified to comply with ANSI A112.19.4.M
U.S. Patent No. 4,664,982
please read these instructions carefully before you begin.
Other patents pending.
CAN/C.S.A. B-45
Observe local plumbing and building codes.
Refer to American Standard roughing-in informa

ملخص المحتوى في الصفحة رقم 2

® INSTRUCTIONS FOR COUNTERTOP MOUNTING. AFTER THE CUTOUT IS DRAWN... 1 4 Cutout Perimeter of sink Sink Masking outline tape 1/8" Cutout outline Remove sink and apply a masking tape Drill a clearance hole inside the cutout line outline 1/8" outside traced outline as a as marked on the countertop. guide for application of silicone sealant. 2 5 Apply a generous portion of silicone sealant inside line traced on countertop. Carefully lower sink into place and press down Perimeter firmly. Use gu

ملخص المحتوى في الصفحة رقم 3

® INSTRUCTIONS FOR UNDERCOUNTER MOUNTED SINK WITH COUNTERTOP MOUNTED FAUCET. 1 5 Apply a bead of sealant to Countertop Countertop Cutout the edge of the sink. Hold Perimeter Edge the sink against the of sink Sealant under-side of the countertop and rotate the clips to hold the sink in Cutout place. Snug the screws to hold the sink. Attach all the 12mm (1/2") additional clips. Drill a clearance hole inside the cutout line Support Clip as marked on the countertop. 2 6 Countertop Counterto

ملخص المحتوى في الصفحة رقم 4

® INSTRUCTIONS FOR UNDERCOUNTER MOUNTED SINK WITH SINK TOP MOUNTED FAUCET. Countertop 1 7 Drill a clearance Perimeter hole inside the of sink cutout line as Trap B marked on the A Single Bowl countertop. Cutout Cut opening on cut line inside the perimeter of the template. 2 Note - Formica Connect drain assembly hand tight to check alignment. It Countertop countertop installation may be necessary to cut off part of the tailpiece (area "A") or Perimeter only is illustrated. Contact part o